489588
63
Zoom out
Zoom in
Previous page
1/80
Next page
63
Maintenance and Care
The WARNING TEMP. indicator shows the state of the function which protects the projector. Check the state
of the WARNING TEMP. indicator and the POWER indicator to take proper maintenance.
WARNING TEMP. indicator
The projector is shut down and the WARNING TEMP.
indicator is blinking red.
When the temperature inside the projector reaches a
certain level, the projector is automatically shut down to
protect the inside of the projector. The POWER indicator
is blinking while the projector is being cooled down. When
the projector has cooled down sufficiently (to its normal
operating temperature), it can be turned on again by
pressing the POWER ON/STAND-BY button.
Note:
After the temperature inside the projector returns to
normal, the WARNING TEMP. indicator still continues
to blink. When the projector is turned on again, the
WARNING TEMP. indicator stops blinking.
Then check the matters below:
Did you provide appropriate space for the projector to
be ventilated? Check the installing condition to see if
ventilation slots are not blocked.
Is the projector not installed near the ventilation duct of
air-conditioning equipment which may be hot? Install
the projector away from the ventilation duct of air-
conditioning equipment.
Is the air filter clean? Replace the filter periodically.
(p.52)
The projector is shut down and the WARNING TEMP.
indicator emits a red light.
When the projector detects an abnormal condition, it is
automatically shut down to protect the inside and the
WARNING TEMP. indicator becomes red. In this case,
disconnect the AC power cord and reconnect it, and then
turn the projector on once again for check. If the projector
cannot be turned on and the WARNING TEMP. indicator
emits a red light, disconnect the AC power cord and
contact the service station for check and repair.
CAUTION
DO NOT LEAVE THE PROJECTOR WITH THE
AC POWER CORD CONNECTED UNDER THE
ABNORMAL CONDITION. IT MAY RESULT IN
FIRE OR ELECTRIC SHOCK.
Top Control
WARNING TEMP.
blinking red
Top Control
WARNING TEMP.
lights red
63


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanyo PLC-XC50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanyo PLC-XC50 in the language / languages: English as an attachment in your email.

The manual is 5,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sanyo PLC-XC50

Sanyo PLC-XC50 User Manual - Dutch - 80 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info