Turn off the projector and unplug the AC power cord. Let the
projector cool for at least 45 minutes.
Loosen the screw and open the lamp cover. Loosen 3 screws
of the lamp and pull out the lamp by using the built in handle.
1
3
Replace the lamp with a new one. Make sure that the lamp is
properly and fully inserted.
4
2
Connect the AC power cord to the projector and turn on the
projector.
Follow these steps to replace the lamp.
5
PNote:
Be sure to insert the lamp in the correct direction.
For continued safety, replace with a lamp of the
same type. Do not drop the lamp or touch the glass
bulb! The glass can shatter and may cause injury.
Allow a projector to cool for at least 45 minutes
before you open the lamp cover. The inside of the
projector can become very hot.
CAUTION
CAUTION
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and the Lamp replacement icon appears on the screen andthe Lamp replacement icon appears on the screen and
LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE
indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Lamp replacement icon
PNote:
The Lamp replacement icon will not appear when the Display function is
set to Off (p.52), during "Freeze" (p.30) or "No show" (p.29).
Close the lamp cover and secure the screw.
Lamp
Handle
Lamp cover
Screw
Maintenance and Care
New Lamp
Lamp Replacement
When replacing the lamp because it has stopped illuminating,
there is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed
on the ceiling, you should always assume that the lamp is
broken, and you should stand to the side of the lamp cover,
not underneath it. Remove the lamp cover gently. Small
pieces of glass may fall out when the lamp cover is opened.
If pieces of glass get into your eyes or mouth, seek medical
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Sanyo PLC-WM 4500 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Sanyo PLC-WM 4500 in the language / languages: English as an attachment in your email.
The manual is 10,4 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
