When controlling the computer
with Remote Control of this
projector, connect the mouse
port of your personal computer
to this connector. (Refer to
P12.)
Connect the S-VIDEO
output from video
equipment to this
jack. (Refer to P13.)
Connect the audio output
(stereo) from computer to
this jack. (Refer to P12.)
Connect the audio output
from video equipment to
these jacks.
(Refer to P13.)
● When the audio output
is monaural, connect it
to L (MONO) jack.
CONTROL PORT CONNECTOR
COMPUTER AUDIO
INPUT JACK
AUDIO INPUT JACKS
VIDEO INPUT JACKS
S-VIDEO INPUT JACK
Connect the composite video
output from video equipment
to VIDEO/Y jack or connect
the component video outputs
to VIDEO/Y, Pb/Cb and
Pr/Cr jacks. (Refer to P13.)
COMPUTER INPUT
(DIGITAL/ANALOG)
Connect an external
audio amplifier to these
jacks.
(Refer to P12, 13.)
AUDIO OUTPUT JACKS
This projector uses a micro
processor to control this unit,
and occasionally, this micro
processor may malfunction
and need to be reset. This
can be done by pressing
RESET button with a pen,
which will shut down and
restart the unit. Do not use
RESET function excessively.
RESET BUTTON
When controlling the computer
with Remote Control of this
projector, connect USB port of
your personal computer to this
connector. (Refer to P12.)
USB CONNECTOR (Series B)
This terminal is switchable and
can be used as computer input
or monitor output. Set the
terminal up as either Computer
input or Monitor output properly
before using this terminal.
(Refer to P12, 36.)
Note:This terminal outputs
analog signal from
COMPUTER IN 1 DVI-I
terminal only.
COMPUTER INPUT / MONITOR
OUTPUT TERMINAL
Connect computer
output (Digital / Analog
DVI-I type) to this
terminal. (Refer to P12.)
