598874
74
Zoom out
Zoom in
Previous page
1/98
Next page
Maintenance and Care
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
Loosen the screws and open the lamp cover. Loosen
3 screws of the lamp and pull out the lamp by using
the built in handle.
1
3
Replace the lamp with a new one. Make sure that the
lamp is properly and fully inserted.
4
2
Connect the AC power cord to the projector and turn
on the projector.
Follow these steps to replace the lamp.
5
Note:
Besuretoinsertthelampinthecorrectdirection.
For continued safety, replace with a lamp
of the same type. Do not drop the lamp
or touch the glass bulb! The glass can
shatter and may cause injury.
Allow a projector to cool for at least 45 minutes before
you open the lamp cover. The inside of the projector can
become very hot.
CAUTION
CAUTION
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on
the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The
timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Lamp replacement icon
Note:
TheLampreplacementiconwillnotappearwhenthe
DisplayfunctionissettoOff (p.54)orduring“Freeze”
(p.29)
Close the lamp cover and secure the screw.
Lamp Replacement
When replacing the lamp because it has stopped
illuminating, there is a possibility that the lamp may be
broken.
If replacing the lamp of a projector which has been
installed on the ceiling, you should always assume that
the lamp is broken, and you should stand to the side of
the lamp cover, not underneath it. Remove the lamp cover
gently. Small pieces of glass may fall out when the lamp
cover is opened.
If pieces of glass get into your eyes or mouth, seek
medical advice immediately.
CAUTION
Lamp
Handle
Lamp cover
Screw
Filter cover
74
74


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanyo PLC HP7000L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanyo PLC HP7000L in the language / languages: English as an attachment in your email.

The manual is 19,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info