464614
42
Zoom out
Zoom in
Previous page
1/45
Next page
42
MAINTENANCE
CARE AND CLEANING
Wipe the oven inside and outside
with a soft cloth and a mild detergent
solution. Then rinse and wipe dry.
This should be done on a weekly
basis, more often if needed. Never
use cleaning powders or rough pads.
Excessive oil splatters on the inside
top will be difficult to remove if left for
many days. Wipe splatters with a wet
paper towel, especially after cooking
chicken or bacon.
Stubborn messes:
Boil a cup of water
in the oven for 2 minutes. Steam will
soften the mess. To get rid of odors
inside the oven, boil a cup of water
with some lemon juice in it.
REMOVABLE PARTS
The following parts may be removed
as described. They should be washed
in warm (not hot) water with a mild
detergent and a soft cloth. Once they
are clean, rinse them well and dry
with a soft cloth. Never use cleaning
powders, steel wool or rough pads.
The turntable may be cleaned in
the sink. Be careful not to chip or
scratch the edges as this may
cause the turntable to break
during use.
The turntable roller rest should be
cleaned regularly.
The metal grease filters should be
cleaned once a month or as
needed. Soak grease filters in hot
water and a mild detergent. Scrub
to remove embedded dirt and
grease. Rinse well and shake to
dry. Do not use ammonia,
corrosive cleaning agents such as
lye-based oven cleaner, or place
in a dishwasher. The filter will
turn black or could be damaged.
Metal rack should be washed by
hand with a mild detergent and a
soft sponge or nylon scrub brush.
Dry completely. Do not use
abrasive scrubbers or cleansers.
After each use of the temperature
probe, wipe with a soft damp
cloth.
SPECIAL CARE
For best performance and safety, the
inner door panel and the oven front
frame should be free of food or
grease buildup. Wipe them often with
a mild detergent. Then rinse and wipe
dry. Never use cleaning powders or
rough pads.
After cleaning the control panel, press
STOP/CLEAR
to clear any entries that
might have been entered accidentally
while cleaning the panel.
COOKTOP LIGHT REPLACEMENT
When cooktop light does not light,
replace the bulb. Follow instructions
below for replacement.
1. Disconnect the power.
2. Remove the screw and carefully
remove the cover.
3. Replace bulb with a 40-watt
incandescent bulb available from
an authorized Sanyo Service
Center (see page 44).
4. Replace the cover and put the
screw back in.
5. Plug in oven or reconnect power.
Caution:
Be sure the power is disconnected at
the house circuit breaker or unplug
the power supply cord. If light is
damaged, contact an Authorized
Sanyo Factory Service Center.
S9000sci-Maint.fm Page 42 Wednesday, September 22, 1999 2:40 PM
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanyo EM-S9000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanyo EM-S9000 in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info