521323
12
Zoom out
Zoom in
Previous page
1/16
Next page
12
Clean the device using a damp cloth, to
which you can apply a little detergent if
necessary.
Do not use abrasive detergents and never
immerse the unit in water.
Important
Ensure that no water penetrates inside the
unit!
Do not put the device or accessories in a
dishwasher.
Do not touch the unit with wet hands while
it is plugged in; do not allow any water to
be sprayed onto the unit. The unit must be
operated only when it is completely dry.
Do not spray any liquids into the ventilation
slots. Any liquid that penetrates into the
unit can damage the electrical parts or
other components of the nebuliser and im-
pair the function of the device.
Condensation, care of the hose
Depending on the environmental condi-
tions, condensation may collect in the
hose. To prevent against bacterial growth
and to ensure effective therapeutic use,
this moisture must always be removed. To
remove moisture from the hose, proceed
as follows:
Remove the hose [8] from the atomiser
[9].
Leave the hose plugged into the nebu-
liser [6].
Run the nebuliser until all the moisture
has been displaced by the flow of air.
In the event of significant contamination,
replace the hose.
Disinfection
Follow the steps listed below carefully in or-
der to disinfect your atomiser and the acces-
sories. It is advisable to disinfect the individ-
ual components after the last time they are
used each day at the latest. (For disinfection,
you will simply require a small amount of
clear vinegar and distilled water).
First clean the atomiser and the accesso-
ries as described under “Cleaning”.
Make up a vinegar solution consisting of
¼ vinegar and ¾ distilled water. Ensure
that there is sufficient solution to fully im-
merse all parts such as the nebuliser,
mask, and mouthpiece.
Leave the components in the vinegar solu-
tion for 30 minutes.
Rinse the atomiser and the individual
components (mask/mouthpiece etc.) with
water.
Carefully dry all components using a soft
cloth.
Once all components are fully dry, reas-
semble the atomiser and place the com-
ponents in a dry, sealed container.
Note:
Ensure that all parts are thoroughly dried dur-
ing, and in particular after cleaning, otherwise
there is an increased risk of bacterial growth.
Drying
Place the individual components on a
dry, clean and absorbent surface and al-
low to dry completely (for at least 4
hours).
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanitas SIH20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanitas SIH20 in the language / languages: English as an attachment in your email.

The manual is 1,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Sanitas SIH20

Sanitas SIH20 User Manual - German - 32 pages

Sanitas SIH20 User Manual - Dutch, French - 32 pages

Sanitas SIH20 User Manual - Italian - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info