681495

Sanitas SBM 38 Manual

17
Zoom out
Zoom in
Previous page
1/52
Next page
17
Now tighten the free end of the cuff,
but make sure that it is not too tight
around the arm and close the
hook-and-loop fastener.
The cuff should be fastened so that
two fingers fit under the cuff.
Now insert the cuff line into the con-
nection for the cuff connector.
Important: The unit may only be ope-
rated with the original cuff. The cuff is
suitable for an arm circumference of 22 to 32 cm.
Adopting the correct posture
•
Before every measurement, relax for about five minutes. Oth-
erwise deviations can occur.
•
You can take the measurement while sitting or lying. Make
sure that the cuff is at heart level.
•
To take your blood pressure, make sure you are sitting com-
fortably with your arms and back leaning on something. Do
not cross your legs. Place your feet flat on the ground.
•
To avoid falsifying the measurement, it is important to remain
still during the measurement and not to speak.
Performing the blood pressure measurement
•
As described above, attach the cuff and adopt the posture in
which you want to perform the measurement.
•
To start the blood pressure monitor, press the START/STOP
button . All displays will illuminate briefly. The blood pres-
sure monitor automatically begins to take the measurement;
the cuff automatically inflates.
You can cancel the measurement at any time by pressing
the START/STOP button .
•
The cuff’s air pressure is slowly released. If a tendency for
high blood pressure is already recognised, the cuff is rein-
flated and the cuff’s pressure is increased again. As soon as
a pulse is found, the pulse symbol is displayed.
•
The systolic pressure, diastolic pressure and pulse rate
measurements are displayed.
•
E_ appears if the measurement could not be performed prop-
erly. Observe the chapter on error messages/troubleshooting
in these instructions for use and repeat the measurement.
•
The measurement is automatically stored.
•
To switch the monitor off, press the START/STOP button .
If you forget to turn off the device, it will switch off automati-
cally after approx. 1 minute.
W
ait at least 5 minutes before taking another measurement!
Evaluating results
Cardiac arrhythmia:
This unit can identify potential disruptions of the heart rhythm
when measuring and if necessary, indicates this after the
measurement with the symbol
.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanitas SBM 38 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanitas SBM 38 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 8,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info