532750

Sanibroyeur SANICONDENS Clim pack Manual

3
Zoom out
Zoom in
Previous page
1/18
Next page
SFA
SANICONDENS Clim mini
1. Box contents
SANICONDENS Clim mini comprises two components:
- Pump unit
- Triple-level sensor
2. Warning notice
SANICONDENS Clim mini
3. Technical data
4. Installation
A – Level Sensor unit
4
Magnet facing upwards.
4
Cover on.
4
Connect the short pipe (150mm)
to the lid vent, point it upwards
and secure.
4
Fit the level sensor horizontally
using the support supplied.
B – Pump unit
4
Install the pump in the trunking
1
or in the suspended ceiling
2
.
Make sure the the pump is pointing in the right direction (see arrows on the pump unit).
4
Install the pump vertically (preferably).
4
Make sure there is enough room around the pump unit for it to cool off in the event
of prolonged usage.
4
Ensure that electrical connections are not exposed to water.
C – Hydraulic connections
4
Feed the incoming condensate to the level sensor inlet (1).
4
Connect the pump and the level sensor up using the pipe supplied (2).
4
Evacuation (3):
• The pump outlet must be connected to the waste water discharge
using a suitable fitting with an inner diameter of 8 to 10mm
(not supplied).
• Warning: To prevent siphoning, the discharge outlet must be
higher than the condensate tank.
D – Electric connections
4
Connect the level sensor to the pump unit using the cable.
4
To connect the alarm, there are
(usually open/ usually closed) contacts,
interrupting capacity = 5A.
Connect the alarm as shown in the wiring
setup diagram.
4
Electricity supply:
• Plug the pump in (phase, earth, neutral):
- either by way of the air conditioner
- or directly using a 30-mA circuit breaker.
5. Start-up
4
Check pumping direction
(see arrow on the pump unit).
4
Introduce water into the level sensor.
4
Check that the pump starts up and then stops
once the water level has dropped.
4
Check that the connections are all waterproof.
6. Maintenance
4
Maintenance must only be carried out with the appliance switched off.
4
This product must be maintained at the start of each summer season, or regularly if
the pump is used year round.
4
Clean:
• the reservoir,
• the filter,
• the float ball.
• Replace all items and close the reservoir.
1: pump
2: level sensor
2a: lid
2b: float ball
2c: filter
2d: reservoir
2e: stopper
3: rubber elbow
4: pipe 1.5m, Øint 4mm
5: vent connection.
6: cable with coupler
7: support bracket
- Designed only for pumping water.
- State-of-the-art electrical installation.
- Must not run dry.
- Install all level sensors horizontally.
- Install indoors only (domestic or industrial
premises).
- Do not submerge.
- Unplug the appliance prior to
maintenance.
- Point the float ball with the magnet
upwards
16
14
12
10
8
6
4
2
0
0 1 2 3 4 5
6
7 8 9
10
11
12
13
14
15 16 17
Height in metres
Litres per hour
Sound level at 1 m
Maxi. flow rate
Maxi. horizontal discharge
Maximum vertical
discharge
Maximum air vent length
Electricity supply
Power
Thermal protection
Maximum temperature
of water
<24 dB(A)
15 l/h
14 m
6 m
2 m
220-240V-50Hz
22 W
Trips at 70°C and then
automatically resets
35°C
1
2
2
3
NF NO
Discharge pipe (not supplied)
Waste water pipe
Pump unit
Condensate tank
Level Sensor
1
2
SANICONDENS Clim mini is guaranteed for two years subject to correct installation and usage.
UK
purple
black
white
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sanibroyeur SANICONDENS Clim pack at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sanibroyeur SANICONDENS Clim pack in the language / languages: All languages as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info