797016
8
Zoom out
Zoom in
Previous page
1/15
Next page
7
GB
Radio operation-Manual tuning AM/FM
1. Fully extend the FM wire antenna located on the rear of your clock radio. Place the
wire antenna so that it is as straight as possible extending either above or below the
radio.
2. Press the Standby button to turn on your radio.
3. Press the Source button repeatedly to select AM (MW) or FM 1 or 2 frequency band.
4. Press the Tuning up/down button to change the frequency.
5. To see the time or frequency on the screen, press the Display button
Note:
When your radio has any interference in AM band by its adaptor, please move your
radio away from its AC adaptor over 30 cm.
Scan tuning AM/FM
1. Fully extend the FM wire antenna located on the rear of your clock radio. Place the
wire antenna so that it is as straight as possible extending either above or below the
radio.
2. Press the Standby button to turn on your radio.
3. Press the Source button repeatedly to select AM (MW) or FM 1 or 2 frequency band.
4. Press and hold the Tuning up/down button. Your radio will scan in an upwards direction
(low frequency to high frequency) or downwards direction (high frequency to low
frequency) and stop automatically when it nds a station with sufcient signal strength.
Presetting AM/FM stations
1. Press the Standby button to turn on your radio.
2. Press the Source button repeatedly to select AM (MW) or FM 1 or 2 frequency band.
3. Tune into the station that you would like to preset following the steps above.
4. Press and hold one of preset buttons until the radio beeps, the station frequency will
be saved into the chosen preset.
5. Repeat the procedure for the remaining presets. Your radio has 5 presets for each
frequency band.
6. The presets can be overwritten by following the above steps.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sangean RCR-28 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sangean RCR-28 in the language / languages: English as an attachment in your email.

The manual is 0.93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info