17
If the color appears spread out or “smeared” on the screen, the
convergence probably needs alignment. Be sure to use the remote
control for the convergence adjustments. (The Convergence
Adjustment can not be made by using the control buttons on the
front panel.)
1 Press the MENU button.
Result
: The main menu is displayed.
2 Press the ▼ or ▲ button to select Function.
Result
: The options available in the Function group are
displayed.
3 Press the button.
4 Press the ▼ or ▲ button to select Convergence. Press the
button.
Result
: The options available in the Convergence group are
displayed with
Red is selected.
5 Press the button again.
Result
: A crosshair pattern is appeared.
6 Adjust convergence by using your remote control.
◆
Use the ▼/▲/➛/❿ buttons to all directions for select the
position.
◆
Press the “0” button to select red or blue convergence.
◆
To move the line so that it is superimposed on the horizontal
or vertical center-line, use the volume up/down (
VOL
+/
-
) and
channel up/down (
P
/
) buttons (i.e., make a signal
horizontal or vertical line that is as white as possible).
◆
Press the Menu button to exit.
You can adjust convergence automatically for the optimum in the
factory.
7 Select Perfect Focus in the Function group, then press the
button.
Result
: Perform Perfect Focus in the following sequence:
green
➞ red ➞ blue.
After the cursor flickers for one second, the perfect
focus feature ends.
➣
You can also adjust simply by pressing the Perfect Focus
button.
➣
When the size of the sub picture is selected to the “12 PIP”
or “
3 PIP” mode, the Perfect Focus feature does not work.
Adjusting Convergence
ENG
