53806
20
Zoom out
Zoom in
Previous page
1/80
Next page
SAM4S ER-5100 SERIES 5-1
#5
#4
#3
#2
#1
ADJUSTMENT SCALE
ADJUSTMENT POINT
BRACKET P/END SLIDE BRACKET
(SET FOR PAPER THICKNESS = 0.075MM)
5 Alignment and Adjustments
This chapter describes the methods for aligning and adjusting components in this ECR.
5-1 Printer Adjustments
5-1-1 Head Gap Adjustment
1. Assemble the Upper Frame Assembly, A, to the
Lower Frame Assembly, I and loosely fox
screws .
2. Wind the Head Gear counterclockwise to;
move the Head to the right end of the Platen
Guide.
3. Insert the Gap Gauge (width 0.5mm) and
tighten the Head and Platen. Tighten the
screws .
4. Wind the Head Gear counterclockwise again
and move the Head to the left end of the Platen
Guide.
5. Insert the Gap Gauge (0.5mm) and tighten the
screws.
6. After tightening al screws , apply Nej-Lock (a
brand of grease) on each of the four screws .
Figure 5-1. Head Gap Adjustment
5-1-2 Roll Paper Near-End Detector
(Type 1 Paper Sensor)
5-1-2-(a) Adjustment Point
Figure 5-2. Adjustment Point
As Figure 5-2 shows, the slide bracket is set at
Adjustment Scale #3. This is the appropriate scale for the
recommended paper thickness (0.075mm).
The accuracy of the Near-End Detector depends on the
Adjustment Scale setting and the Roll Paper Winding
Core diameter. The only paper approved for use in this
ECR has the following characteristics:
Table 5-1. Roll Paper characteristics
Characteristic Measurement
Paper Thickness 0
075mm
Paper Width
44.5mm ± 0.5mm
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samsung Sam4S ER-5140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samsung Sam4S ER-5140 in the language / languages: English as an attachment in your email.

The manual is 7,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info