629794
10
Zoom out
Zoom in
Previous page
1/64
Next page
Expedition Pro XPL200
Guided Tour
1: Input connector - Use this balanced female XLR connector to route line-level
signal into the XPL200.
2: Output VU meter - This three-segment bar meter shows the XPL200 output
level. For optimum signal-to-noise ratio, set the Volume control (see #6 below)
so that program material is usually at or around 0 VU, with occasional but not
steady excursions to the red “+3 dB segment.
3: Power switch - Use this to turn power to the XPL200 on or off.
4: Battery VU meter - If an optional RB 2030 rechargable battery pack is
installed, this meter shows how much battery power remains as it is being
charged (Power switch off) or depleted (Power switch on).
5: Volume control - This knob sets the level of the XPL200’s built-in power
amplifier.
6: Output connector- This balanced male XLR connector carries line-level out-
put signal from the XPL200. It is used to send signal to a second XPL200 being
daisy-chained (see interconnection diagram on the following page) or to an
optional DB1500 subwoofer.
7: AC input - Connect the supplied heavy-gauge 3-pin “IEC power cable here.
Interconnecting the XPL200
UTILISER UN FUSIBLE
DE RECHANGE DE
MEME TYPE.
AMPLIFIED SPEAKER CABINET
BI-AMPED 15 0 WATTS LOW
50 WATTS HIGH F REQUENCY
SIGNAL OUTPUT
SIGNAL INPUT
AC OUT
350VA MAX
POWER
AC
CAUTION:
ATTENTION:
FOR CONTINUED
PROTECTION
AGAINST RISK
OF FIRE,
REPLACE ONLY
WITH SAME
TYPE OF FUSE.
FUSE: T5AL 250V
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
VOLUME
RATING
POWER
100-240 V ~ 50Hz/60Hz 360W
100
5
LIMITER
AC IN
ON
CHARGE
BATTERY OPERATION
OFF
+3dB
0dB
-10dB
75%
50%
25%
BATTERYMAIN
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
AVIS;
MADE IN CHINA
UTILISER UN FUSIBLE
DE RECHANGE DE
MEME TYPE.
AMPLIFIED SPEAKER CABINET
BI-AMPED 150 WATTS L OW
50 WATTS HIGH FREQUENCY
SIGNAL OUTPUT
SIGNAL INPUT
AC OUT
350VA MAX
POWER
AC
CAUTION:
ATTENTION:
FOR CONTINUED
PROTECTION
AGAINST RISK
OF FIRE,
REPLACE ONLY
WITH SAME
TYPE OF FUSE.
FUSE: T5AL 250V
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
VOLUME
RATING
POWER
100-240 V ~ 50Hz/60Hz 360W
100
5
LIMITER
AC IN
ON
CHARGE
BATTERY OPERATION
OFF
+3dB
0dB
-10dB
75%
50%
25%
BATTERYMAIN
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
AVIS;
MADE IN CHINA
SAMSON
MPL2242
MMPL2242
MPL2242
Using one XPL200: A single mono signal (bus or aux send) is
routed from a mixer to the XPL200 XLR input.
ENGLISH
6
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson XPL200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson XPL200 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 10,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info