630064
11
Zoom out
Zoom in
Previous page
1/54
Next page
11
Guided Tour - VH3
1: Audio on-off switch - When set to the on
position, audio signal is transmitted. When set to
the off position, the audio signal is muted.
Because the carrier signal remains during muting,
no pop or thud will be heard. Note that turning
this off does
not turn off the transmitter powerit is
simply a way to temporarily mute the transmission
of audio signal. If you dont plan on using the VH3
for extended periods, turn off its power by using
the power on-off switch (see #3 below).
2: Battery level meter - This set of three
multicolor LEDs indicates relative battery power,
indicating whether the installed battery is at low
(red), mid (yellow) or high (green) strength.
One or more of these will light whenever the VH3
is powered on (see #3 below). When all three are
lit, the battery is at maximum strength. When only
the red low indicator lights, RF performance is
degraded and the battery needs to be replaced.
3: Power on-off switch* - Use this to turn the
VH3 on or off (to conserve battery power, be sure
to leave it off when not in use).
4: Gain control (trimpot) - This input sensitivity
control has been factory preset to provide optimum
level for the particular microphone capsule provided with your VHF TD Series or
VHF Series system and so we recommend that this not be adjusted manually. If neces-
sary, however, you can use the supplied plastic screwdriver to raise or lower the input
level. See the Setting Up and Using Your VHF TD Series / VHF Series System section
on page 10 in this manual for more information.
5: Battery holder - Insert a standard 9-volt alkaline battery here, being sure to observe
the plus and minus polarity markings shown. We recommend the Duracell MN 1604 type
battery. Although rechargeable Ni-Cad batteries can be used, they do not supply
adequate current for more than four hours.
WARNING: Do not insert the battery
backwards; doing so can cause severe damage to the VH3 and will void your warranty.
* Be sure to mute the audio signal at your external mixer or amplifier before turning
transmitter power on or off, or an audible pop may result.
SAMSON
MIN
MAX
LEVEL
POWER
ON
OFF
5
3
4
1
2
AUDIO
LOW MID HIGH
BATTERY LEVEL
Ch2
OFF ON
F
C
C
I
D
C
C
R
V
H
3
B
Z
T
x
x
x
x
x
x
x
x
C
A
N
A
D
A
:
X
X
X
X
X
X
X
X
X
ENGLISH
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson VHF Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson VHF Series in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info