629780
7
Zoom out
Zoom in
Previous page
1/45
Next page
7
Guided Tour - UT1L / UT1G
1: Input connector - The input device is connected here. The UT1L is supplied with
either a lavalier or headset microphone (connected via a Switchcraft mini-XLR jack), while
the UT1G is supplied with a permanently connected 1/4" jack cable.
2: Battery level meter - This set of three multicolor LEDs indicates relative battery
power, indicating whether the installed battery is at low (red), mid (yellow) or high (green)
strength. One of these will light whenever the UT1L or UT1G is powered on (see #8 on
the next page). When the red low indicator lights, RF performance is degraded and the
battery needs to be replaced.
3: Audio on-off switch - When set to the on position, audio signal is transmitted.
When set to the off position, the audio signal is muted. Because the carrier signal
remains during muting, no pop or thud will be heard. Note that turning this off does
not
turn off the transmitter powerit is simply a way to temporarily mute the transmission of
audio signal. If you dont plan on using the transmitter for extended periods, turn off the
transmitter power by using the power on-off switch (see #8 on the next page).
4: Belt clip - Use this clip to fasten the UT1L or UT1G to a belt. The position of the clip
can be rotated to the desired position after loosening its
center screw or can be removed entirely by removing
the center screw.
5: Battery cover release - Slide the release lever down
to open the UT1 battery cover.
6: Antenna - This permanently attached transmitter
pig tailantenna should be fully extended for normal
operations. See the Setting Up and Using the Series
One System section on page 8 in this manual for more
information about antenna positioning.
7: Battery holder - Insert a standard 9-volt alkaline
battery here, being sure to observe the plus and minus
polarity markings shown. We recommend the Duracell
MN 1604 type battery. Although rechargeable Ni-Cad
batteries can be used, they do not supply adequate
current for more than four hours.
WARNING: Do not
insert the battery backwards; doing so can cause severe
damage to the UT1L / UT1G and will void your warranty.
4
1
LOW
MID
HIGH
BATT
AUDIO
2
3
SAMSON
UT1
5
6
ENGLISH
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson UHF Series 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson UHF Series 1 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info