629991

Samson S.phone Manual

9
Zoom out
Zoom in
Previous page
1/19
Next page
Operating the S•phone
• Repeat the previous step for all Channels that have headphones connected, making sure to start the
VOLUME knob completely counterclockwise and then slowly raising it until the desired level is achieved.
If you have connected different models of headphones to the various Channel Headphone jacks, you
may find that some require more gain than others to achieve the same volume. This kind of disparity will
occur if the various headphones have different impedances. The lower the impedance, the louder the
headphone will sound compared to another, higher impedance headphone at the same VOLUME setting.
Another factor affecting headphone loudness is called sensitivity. This is generally measured by deter-
mining the decibel (dB) level generated by 1 mW of power input. The higher the dB rating, the louder the
headphone. See the Reference chart on page 16 of this manual for more details.
• To achieve optimum signal-to-noise ratio, the MASTER VOLUME should generally be set as high as pos-
sible, short of audible distortion. However, if this results in your getting blasted with signal even though
the channel volume is near minimum, you’ll need to decrease the Master Volume while raising one or
more channel volume levels. Conversely, if you find that you have to raise one or more headphone
Channel Volume knobs to maximum or near maximum to achieve the desired level, try increasing the
Master Volume Level while decreasing the channel volume(s).
SETTING UP THE S•phone - Continued
S • Phone Master Section
Master Volume
The S phone’s MASTER VOLUME control is used to
adjust the input signal connected to the MAIN Left and
Right inputs. In addition, the MASTER VOLUME control
adjusts the level of the signal inserted in the MASTER
INJECT, which is summed with the MAIN Left and Right
input signal.
Master Level meter
The S•phone’s maser section includes an 8 segment LED
LEVEL meter which monitors the input level of the MAIN
Left and Right Inputs in Decibels (dBs) from –30 to CLIP.
If the LEVEL meter displays a CLIP signal, then turn down
the signal being sent into the MAIN left and Right.
5
10OFF
MASTER
VOLUME
INJECT
MASTER LEVEL dB
-30 -18 -12-24 -6 +6 CLIP0
HEADPHONE
MIXER/AMP
AUX MAIN
1
2
3
Using the Master Inject
The S•phone’s MASTER INJECT is a TRS input (Tip, Ring, Sleeve) that allows a second stereo signal to be
inserted and summed together with the MAIN Left and Right signals. You can use a stereo signal from your mix-
ers buss outputs or auxiliary sends to balance the mix between two stereo signals like rhythm tracks and vocals.
3
1
2
7
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson S.phone at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson S.phone in the language / languages: English as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info