629800
9
Zoom out
Zoom in
Previous page
1/16
Next page
9
MXS Series Power Amplifiers
Getting Started with the MXS Power Amplier
Setting up your MXS Series is a simple procedure which takes only a few minutes:
Remove all packing materials (save them in case your units needs future service) and
decide where the amplifier is to be physically placed—it can be used free-standing or
mounted in a standard 19” rack, requiring two rack spaces. When installed, make sure
that both the front and rear panels are unobstructed and that there is good ventilation
around the entire unit.
When making speaker connections, use the
binding posts, or Speakon® output connectors
on the rear panel. It is never a good idea to
power up any amplifier that is not connected to
loudspeakers.
To make the signal input connections, use the
input connectors on the rear panel (if operating the
amplifier in Parallel mode, use the Ch A input only).
On the front panel of the MXS Series, turn both Channel level controls fully
counterclockwise (to their minimum setting). Then connect the supplied heavy-gauge
3-pin power cable to the rear panel AC input and to any grounded AC socket.
Turn the Power switch ON.
Apply an input signal to the
MXS Series at or about +4dBu
(if sending signal from a mixer,
drive the output meters at
approximately 0 vu). While the
input signal is present, slowly
raise the Channel level controls
until the desired sound level is
achieved. For the best signal-
to-noise ratio, the MXS Series
should normally be run with the
Channel Input controls at or
near maximum (fully clockwise)
and the PEAK segments should
light occasionally (but not
frequently) during maximum
levels.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson MXS3500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson MXS3500 in the language / languages: English as an attachment in your email.

The manual is 2,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Samson MXS3500

Samson MXS3500 User Manual - German, French, Italian, Spanish - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info