629652
13
Zoom out
Zoom in
Previous page
1/112
Next page
13
MXP124/MXP124FX
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
Stereo Input Channel Section
The following section details four stacked stereo input channels.
11. Stereo ¼” Input Jacks - Use the ¼” jacks for connecting stereo
line level sources. For stereo inputs use the LINE L to connect
the left channel and the LINE R to connect the right channel.
Use the LEFT input when connecting a mono input signal to
the Stereo Input channels. You can connect outputs from high
impedance microphones, synthesizers and drum machines to
these inputs. The LINE inputs have a nominal operating level
of -40dBV through - 10dBV.
TRS phone jacks Connector pin-out - Sleeve: Ground, Tip: Hot (+), Ring:
Cold (-)
12. FX Auxiliary Control (MXP124FX) - FX Auxiliary
Control - The channel’s FX knob controls the
amount of signal that is sent to the effects bus.
The signal of the FX bus in the MXP124FX is
routed to the Digital Effects section for on-
board signal processing. The FX signal can also
be sent to an external effect device connected
to the FX SEND jack located on the front panel
jack field.
MON Auxiliary Control (MXP124) - Controls the amount of that channel’s
signal that is sent to the MON Output. The signal feeding MON is sent
before, or pre, the channel fader, so the channel fader has no effect on
the MON level. The MON is usually used to create a separate mix for a
floor monitor system.
13. BAL Control - This control is used to place, or position, the stereo signal
into the main left and right stereo mix field. You can create a stereo
image by panning some input signals to the left and others to the right.
14. PEAK Indicator - This LED indicator will flash RED when the channel
input signal peaks. To reduce distortion, turn the LEVEL control
counterclockwise or lower the volume of the input device until the clip
indicator does not light during normal use.
15. LEVEL Control - This knob controls the volume of channel inputs and is
used to continuously adjust the loudness of the various signals being
blended together at the Main Outputs.
Top Panel Controls
11
12
13
14
15
11
12
13
14
15
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson MXP124FX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson MXP124FX in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 7,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info