BALANCE (Stereo Inputs Only)
The MDR1064’s BALANCE control is used to place or position the
stereo signal into the main Left and Right MIX bus. You can move a
stereo signal’s image to the left or right by setting the BALANCE
control to the left or to the right.
PAN (Mono Inputs Only)
The MDR1064’s PAN control is used to place or position the mono
signal into the stereo main Left and Right MIX bus. You can create a
stereo image by panning some input signals to the left and others to
the right. The MDR1064’s PAN control is a Power-Pan circuit, which
includes a 3dB dip in the center position. This is desirable since
there’s a 3dB increase in gain when the mono input signal is heard
in both the Left and Right MIX bus.
PEAK LED
The MDR1064’s MIC/LINE pre-amp also includes a PEAK LED
which, when illuminated, indicates that the signal is peaking or over-
loading. To reduce distortion, lower the GAIN control to keep this
LED from staying on.
CHANNEL LEVEL
The MDR1064’s LEVEL control knobs are used to adjust the overall
channel volume.
Controls and Functions
(MONO/STEREO INPUT CHANNEL CONTINUED)
NOTE
: The channel’s AUX 2 signal is sent to the AUX 2 bus from a location in the signal path after the
channel’s LEVEL control. This is commonly referred to as a POST FADER send. This means that the
amount of signal that is sent to the AUX 2 bus will be affected not only by the setting of the AUX 2 knob
control, but it will also be affected by the setting of the LEVEL control.
7
8
9
8
9
7
7
6
6
