623998
13
Zoom out
Zoom in
Previous page
1/84
Next page
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
XP150 Mixer Layout
7. REVERB Switch – Use the REVERB switch to add an eect to a Mic or Line input on
any of the inputs 1–3. The REVERB LED indicator lights GREEN when the REVERB is
ON.
8. REVERB Indicator –The REVERB LED will illuminate when the REVERB switch is
pressed down, indicating the channel is set to add reverb (see #7 above).
9. VOLUME Control Knob – This knob sets the overall level for each channel’s Mic or
Line input. NOTE: To reduce noise, set the VOLUME controls on any unused chan-
nels to the minimum setting.
10. SPEAKER OUT Jacks – The XP150 has two ¼-inch phone connectors, which are
powered outputs used to connect your left and right speakers. Use the included
speaker cables to connect the speakers.
CAUTION: The total impedance load for each side of the amplier must not be less
than 8 Ohms. Do not connect additional speakers to the XP150 mixer.
11. SPEECH/MUSIC Switch – The SPEECH/MUSIC switch is used to change the overall
frequency response, or tone contour, for the XP150 sound system. If your ap-
plication is mainly for music, press the switch down to select the MUSIC response
curve. If your application is mainly for speech, leave the switch up to select the
SPEECH response curve.
12. REVERB Control Knob – The REVERB control knob is used to adjust the total
amount of reverb added to all channels with their REVERB switch (see #7 above)
pressed down.
13. MASTER Volume Knob – The MASTER volume knob controls the overall output
level. Signals from all ve channels are routed here just before being routed to the
built-in power ampliers and Left and Right output jacks (see #10 above).
14. POWER Switch – Use the POWER switch to turn power to the XP150 on or o.
15. Power/Peak Indicator – This LED will illuminate GREEN when the MAIN power
switch is turned on, and light RED when the when the amp is near the clipping
point. If the Peak indicator lights frequently, turn down the MASTER volume con-
trol or turn down the input channel VOL controls, until the indicator does not light
anymore, or lights only occasionally with signal peaks.
16. IEC Inlet – Connect the supplied heavy-gauge 3-pin “IEC” power cable here.
17. Mixer Lock – Turn this quarter turn lock counterclockwise, to the RELEASE poisi-
tion, to remove the mixer from the rear of the speaker cabinet. When transporting
the XP150, make sure the lock is in the LOCK position.
Owner's Manual
13
Expedition XP150
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson Expedition XP150 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson Expedition XP150 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 11,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info