629789
9
Zoom out
Zoom in
Previous page
1/60
Next page
7
Expedition Pro XP200
Guided Tour
1: Input connector - Use this balanced female XLR connector to route line-
level signal into the XP200.
2: Output VU meter - This three-segment bar meter shows the XP200 output
level. For optimum signal-to-noise ratio, set the Volume control (see #6 below)
so that program material is usually at or around 0 VU, with occasional but not
steady excursions to the red “+3 dB” segment.
3: Power switch - Use this to turn power to the XP200 on or off.
4: Voltage selector - Make sure this is set correctly for the country you are in
before turning on the power to the XP200.
5: Battery VU meter - If an optional RB 2030 rechargable battery pack is
installed, this meter shows how much battery power remains as it is being
charged (Power switch off) or depleted (Power switch on).
6: Volume control - This knob sets the level of the XP200’s built-in power
amplifiers.
7: Output connector- This balanced male XLR connector carries line-level out
-
put signal from the XP200. It is used to send signal to a second XP200 being
daisy-chained (see interconnection diagram on the following page) or to an
optional EX500 subwoofer.
8: Limiter switch - Use this switch to turn the built-in limiter circuitry on or off.
In order to maximize speaker protection, we recommend that this switch be left
in the on” position during normal operation.
9: AC input - Connect the supplied heavy-gauge 3-pin “IEC” power cable here.
Interconnecting the XP200
!
0
10
5
!
0
10
5




Using one XP200: A single mono signal (bus or aux send) is
routed from a mixer to the XP200 XLR input.
ENGLISH
7
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson Expedition Pro XP100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson Expedition Pro XP100 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 10,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info