630000
25
Zoom out
Zoom in
Previous page
1/28
Next page
23
Installing the AI01 / 02, Analog Input / Output
1. Open the top cover by removing the six screws shown
in Figure 1.
2. Remove the four screws of the blank panel and the
panel itself.
3. Thread the two ribbon wires through the slot. Install
the panel into the chassis using the four screws re-
moved in step 2. (See Figure 2)
4. If the AI01 (or 02) is mounted into the upper chassis
slot, attach the end of the large, gray ribbon con-
nector into the socket labeled JP2 on the D-CLASS
DSP MAIN printed circuit board. If the AI01 (or 02) is
mounted into the lower chassis slot, attach the large
ribbon connector into the socket labeled JP1. There is
a notch in the socket that must line up with the tab on
the bottom of the connector.
(See Figure 3)
5. Carefully push down on the connector and it will
engage the locking tabs on either side.
6. Attach the end of the small ribbon cable connector
to the jack labeled CN5 (and / or CN7 if installing a
second Analog I/O) on the D-CLASS POWER printed
circuit board. Note that the two notches on the con-
nector must line up with the notches on the jack. Push
the plug down into place.
(See Figure 3)
7. Slide the top cover back on and replace the six screws.
Installing the Optional AI 02, Analog Input / Output
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES
CLASS B
. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MUST NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.


Figure 1
Figure 1
Figure 2
Figure 2
Figure 3
Figure 3
D3500_ownman_v1_2.indd 23 9/4/05 5:21:36 PM
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson D-3500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson D-3500 in the language / languages: English as an attachment in your email.

The manual is 7,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info