Manual Samson Concert 77 (page 10 of 47) (English, German, French, Spanish)

623980

Zoom out

Zoom in

1/47

ENGLISH

Setting Up and Using the

Concert Series System

The basic procedure for setting up and using your Concert Series Wireless System takes only a

few minutes:

1. For the Concert Series system to work correctly, both the receiver and transmitter must be set

to the same channel. Remove all packing materials (save them in case of need for future service)

and check to make sure that the supplied CR77 receiver and CT7 or HT7 transmitter are set to

the same channel. If these channels do not match, contact your distributor or, if purchased in

the United States, Samson Technical Support at 1-800-372-6766.

2. Physically place the CR77 receiver where it will be used (the general rule of thumb is to main-

tain “line of sight” between the receiver and transmitter so that the person using or wearing

the transmitter can see the receiver). An optional rack-mount kit (available from your Samson

dealer) allows the CR77 to be mounted in a standard 19" rack if desired. Extend both “A” and “B”

antennas and place both in a vertical position.

3. Make sure the Power on-off switch in your CT7 belt-pack or HT7 handheld transmitter is set to

“Off.”

4a. If your system contains a CT7 belt-pack transmitter, push in both sides of the battery cover

and pull back to open the battery door, which is hinged and not intended to be removed from

the transmitter case. Please use care when opening this door as undue force will destroy the

hinge.

4b. If your system contains a HT7 handheld transmitter, unscrew the bottom section of the

microphone by turning it counterclockwise and then slide it off.

5. Place a fresh 9-volt alkaline battery in the transmitter battery holder, taking care to observe

the polarity markings. If you are using a CT7 belt-pack transmitter, gently replace the battery

door by swinging it up and pressing until it clicks. If you are using a HT7 handheld transmitter,

replace the bottom section of the microphone by sliding it on and then screwing it back on.

Whichever transmitter you are using, leave it off for the moment.

6. Make the physical cable connection between the CR77 output jack and the line or mic level

audio input of your amplifier or mixer. If you are using the balanced XLR jack (preferable, since

it will deliver an electromagnetically cleaner signal), be sure to set the CR77 rear panel Audio

Output Level switch correctly. If required, both the balanced and unbalanced outputs can be

used simultaneously. Leave your amplifier (and/or mixer) off at this time.

7. Turn the Volume knob on the CR77 completely counterclockwise. Using the strain relief,

connect the supplied AC adapter to the DC Input on the rear panel of the CR77, then plug the

adapter into any standard AC outlet. Press the front panel Power switch to turn on the CR77; the

red “Power” LED will light up, but all other front panel LEDs will remain unlit.

8. Turn on the power to the CT7 or HT7 transmitter (using its Power on-off switch); the green

“HIGH” Battery strength LED will light if the battery is sufficiently strong. At this point, either the

“A” or “B” green LED on the front panel of the CR77 will light (depending upon which antenna

is receiving the stronger signal). Also, one or more segments in the CR77 front panel RF Level

meter should light; the more are lit, the stronger the RF signal. If only one or two segments light

(indicating a relatively weak signal), try relocating the CR77 or changing the position of one or

both of its antennas. If all six segments light, the CR77 is receiving an optimally strong RF signal

and is placed and positioned correctly.

9. Now it’s time to set the audio levels. Turn on your connected amplifier and/or mixer but keep

its volume all the way down. Next, make sure that your transmitter is unmuted by setting its

Audio switch to “On.” Then set the Volume knob on the CR77 fully clockwise (to its “10” setting);

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Samson Concert 77 in the language / languages: English, German, French, Spanish as an attachment in your email.

The manual is 2,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Samson Concert 77 Manual

Product: