629724
13
Zoom out
Zoom in
Previous page
1/92
Next page
ENGLISH
ESPAÑOLITALIANO FRANÇAISDEUTSCHE
Configuring Your Speaker System
Before you start plugging in cables, you should take a minute to decide how you
want to interface your new Auro D1200. Most system set-ups fall into one of two
categories: Stereo or Mono sub operation.
In most cases, a common (mono) sub
bass setup is preferable. Low frequencies
produced by a subwoofer tend to be non-
directional. Since low frequency waves take
so much space to develop, it is difficult for
the ear to tell if sub bass is coming from
the left or right side (unless, of course
you’re in a very large room). Because of this
phenomenon, just about all sub bass mate-
rial is mixed in mono.
Follow the steps below for a system set-up
using the D1200 with a mixer and a pair of powered satellite loudspeakers.
Lower your mixer’s master outputs until they are turned off.
Connect the mixer’s left output to the D1200 left (A) LINE INPUT, and the mix-
er’s right output to the D1200 right (B) LINE INPUT.
Connect the D1200 left (A) THRU output to the line input of the left side pow-
ered satellite, or power amplifier (if using passive speakers) and the D1200 right
(B) THRU output to the line input of the right side satellite or power amplifier (if
using passive speakers).
Set the level of your powered satellites up to normal operating level. Run an
audio signal (such as music from a CD) through your mixer, and raise the level to
a comfortable listening volume.
Slowly raise the D1200 Level control and adjust the D1200 GAIN control to the
desired low frequency output.
When you raise and lower your mixer’s output, the D1200 and satellites will track
at the same relative volume.
Mono Sub Operation
Auro D1200 Active Subwoofer
13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson Auro D1200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson Auro D1200 in the language / languages: English as an attachment in your email.

The manual is 9,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info