629763
9
Zoom out
Zoom in
Previous page
1/16
Next page
Auro D12/D15Owner's Manual 5
ENGLISH
Choosing the Correct Cables
Impedance
Auro series speaker connections are made via the rear panel ¼” and/or Speakon®
connectors. It is recommeneded that you use standard unshielded speaker wires
(12-14 gauge), available at your local pro audio or music store, with either ¼” phone or
Speakon connectors.
If your amplier uses binding posts, you can use speaker cables with banana plugs, but
be sure to pay attention to the plus and minus polarity when making the connections.
Make sure that the “+” terminal of the speaker, or banana connector, is connected to
the “+” terminal of the power amplier, and that the “-” terminal of the speaker, or ba-
nana connector, is connected to the “-” terminal of the power amplier. For a detailed
wiring diagram, please see page 9 of this manual.
Heres a tip: It’s fairly easy to identify a monitor that is out of phase just by listening,
especially on a pop record. Listen for the parts of the music that you would expect to
be in the center of the mix, like kick drum and vocals. If you do not hear them directly
in the center (for instance they sound like they are two signals panned hard right and
left) then you are more than likely listening to an out-of-phase monitor system. It is
important that your PA system is connected in phase, otherwise you will not have the
proper low-end response and stereo image.
Before you hook up your speaker cabinet, it is useful to learn a little about impedance.
Impedance is the electronic load that the speaker puts on the power amplier, and is
measured in Ohms.
Here is the tricky, yet simple rule of impedance: When two speakers, of equal imped-
ance, are wired in “Parallel”, the total impedance is cut in half. When two speakers are
wired in “Series, the total impedance is the sum of the speakers individual impedance.
The Auro D12 and D15 are each 8 Ohms. So, when two Auro cabinets are connected
in parallel, the total impedance is 4 Ohms. The impedance of your speaker also has
an eect on the amplier. In general, the lower the impedance, the more power your
amplier will deliver.
IMPORTANT NOTE: There is minimum safe impedance for running power ampliers. Be
sure to check the manufacturer’s recommended impedance for your amplier to avoid
any damage, which may void your warranty.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Samson Auro D12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Samson Auro D12 in the language / languages: English as an attachment in your email.

The manual is 2,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info