647728
10
Zoom out
Zoom in
Previous page
1/16
Next page
10
11
11. TROUBLESHOOTING (2)
PROBLEM POSSIBLE CAUSE SOLUTION
LCD shows low battery symbol
LCD shows low battery symbol Change the batteries
LCD shows “Er 0” Pressure system is unstable before
measurement
Don’t move and try again.
LCD shows “Er 1” Fail to detect systolic pressure
LCD shows “Er 1” Fail to detect diastolic pressure
LCD shows “Er 1” Pneumatic system blocked or cu is
too tight during inflation
Apply the cu correctly and
try again
LCD shows “Er 4” Pneumatic system leakage or cu is
too loose during inflation
LCD shows “Er 5” Cu pressure above 300mmHg
Measure again after five minutes.
If the monitor is still abnormal,
please contact the local distributor
or the factory.
LCD shows “Er 6” More than 3 minutes with cu
pressure above 15 mmHg
LCD shows “Er 7” EEPROM accessing error
LCD shows “Er 8” Device parameter checking error
LCD shows “Er A Pressure sensor parameter error
No response when you press button or
load battery.
Incorrect operation or strong
electromagnetic interference
Take out batteries for five minutes,
and then reinstall all batteries.
NOTICE
01. Do not drop this monitor or subject it to strong impact.
02. Avoid high temperature and solarization. Do not immerse the monitor in water as this will result in damage to the
monitor.
03. If this monitor is stored near freezing, allow it to acclimate to room temperature before use.
04. Do not attempt to disassemble this monitor.
05. If you do not use the monitor for a long time, please remove the batteries.
06. It is recommended the performance should be checked every 2 years or after repair. Please contact the service center.
07. Clean the monitor with a dry, soft cloth or a soft cloth squeezed well after moistened with water, diluted disinfectant
alcohol, or diluted detergent.
08. No component can be maintained by user in the monitor. The circuit diagrams, component part lists, descriptions,
calibration instructions, or other information which will assist the user’s appropriately qualified technical personnel
to repair those parts of equipment which are designated repairably can be supplied.
09. The monitor can maintain the safety and performance characteristics for a minimum of 10,000 measurements or
three years, and the cu integrity is maintained after 1,000 open–close cycles of the closure.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Salter BPW-9100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Salter BPW-9100 in the language / languages: English as an attachment in your email.

The manual is 1,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info