663796
9
Zoom out
Zoom in
Previous page
1/12
Next page
CR626USB
Instruction Manual
Alarm Clock Radio with USB Charging
Please read the instruction carefully
before operating the unit.
FR
3
L’heure actuelle est toujours affichée. En changeant le mode Radio, la fréquence sera affichée
pendant environs 5 secondes, après l’appareil reviendra à l’affichage de l’heure.
Fonction chargement USB
Pour charger, connectez votre dispositif USB, tel qu’un smartphone, au port USB de cet appareil.
utiliser exclusivement les dispositifs qui demandent une source d’énergie de 5V. Le port USB
fournit un courant de charge de 1000mA. Ne pas utilisez les dispositifs qui nécessitent un courant
de charge supérieur à 100mA. Le temps de chargement peuvent varier pour les dispositifs
différents.
Note :
x Le fonction de chargement ne peut être pris en charge pour tous téléphones ou
dispositifs électronique.
x La puissance de charge serait environs 80% en mode radio.
Avertissements
x Cet appareil est exclusivement destiné à un usage à l’intérieur et domestique et ne doit
pas être utilisé à aucune autre fin ou pour une autre application, telle qu’une utilisation
non-domestique ou dans un environnement commercial.
x Ne pas bloquer les fentes de ventilation avec des objets, tel qu’un journal, une nappe,
rideaux, etc.
x Ne placez aucune flamme nue, telle qu’une bougie allumée, sur l’appareil.
x Pour réduire le risque de feu, choque électrique ou l’endommage du produit, n’exposez
pas cet appareil au pleut, l’humidité, à égouttures ou éclaboussures. Ne placez pas des
objets remplis de l’eau telles come des vases, sur l’appareil.
x Ventilation, laissez une marge d’au moins de 10 cm autour du produit.
x Cet appareil ne doit pas être utilisé sous un climat tropical.
x Avant le nettoyage de l’appareil, assurez-vous de débranchez-le.
x N’exposez pas les piles (dans l’emballage ou dans l’appareil) à la lumière directe du
soleil ou les sources de chaleur.
x Pour la protection de l’environnement, référez-vous au centre de recyclage local pour
l’élimination des piles.
x Pour déconnecter l’appareil du secteur, la prise doit être débranchée de la pris
électrique du secteur, la prise doit rester facilement accessible.
x La plaque signalétique se trouve en bas de l’enceinte.
Spécifications
FM : 87.5 – 108 MHz
Source d’alimentation : AC 230V ~50 Hz
Batteries de secours : 2 x 1.5V « AAA » ou de type équivalent (pas inclues)
Les produits électriques ne doivent pas être jetés avec les ordures ménagères.
Nous vous prions d’utiliser les centres de recyclage pour l’élimination des produits
électriques.
Consultez votre autorité local ou revendeur pour obtenir des conseils.
Nous nous excusons de tout inconvénient causé par des incohérences mineures, résultant de
l’amélioration et développement du produit.
EN
1
Location of Control
1. Alarm 1 indicator
2. Alarm 2 indicator
3. USB charging port
4. DC5V jack
5. VOLUME - / ALARM 2 button
6. VOLUME + / ALARM 1 button
7. POWER ON/OFF / ALARM
OFF / MODE button
8. HOUR / TUNING < button
9. MINUTE / TUNING > button
10. TIME / MEMORY button
11. SNOOZE / SLEEP button
Power Supply
Mains supply : Insert the AC adaptor into a 230V AC ~ 50Hz mains outlet and the other end
of the cord into the DC 5V jack on the back of the unit.
Battery back up : The clock time and alarm (if set) can be maintained during a power
failure by 2 x AAA/ LR03 batteries (not supplied).
Once the power is restored, check the time to make sure it is accurate and re-set if necessary.
Inserting the Batteries
1. Open the battery compartment at the bottom of the unit by pressing on the catch and
removing the cover.
2. Insert 2 x AAA/ LR03 batteries (preferably alkaline batteries) into the battery compartment,
following the polarity as shown on the diagram inside the compartment.
3. Replace the battery compartment cover
Setting the clock and alarm
Setting the Clock
1. Press and hold the TIME button and the hour/minute digits will flash.
2. Use the HOUR button to set the hours. The PM indicator will light when the hour is
advanced into the PM time.
3. Use the MINUTE button to set the minutes.
4. Press the TIME button to confirm.
Setting the alarm
Before setting the alarm time, make sure the Clock has been set.
1. In standby mode, press and hold AL1 / AL2 until “0:00” flashes on the display.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Salora CR626USB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Salora CR626USB in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 2,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info