Manual Salora 28LED9112CSW (page 45 of 96) (English, German, Dutch, French)

594914

Zoom out

Zoom in

1/96

English - 67 -

• Use a LAN connection for quicker file sharing

between other devices like computers.

• The frequency and channel differ depending on the area.

• The transmission speed differs depending on the

distance and number of obstructions between the

transmission products, the conguration of these

products, the radio wave conditions, the line trafc

and the products that you use. The transmission may

also be cut off or may get disconnected depending

on the radio wave conditions, DECT phones or any

other WiFi 11b appliances. The standard values of

the transmission speed are the theoretical maximum

values for the wireless standards. They are not the

actual speeds of data transmission.

• The location where the transmission is most effective

differs depending on the usage environment.

• The Wireless LAN adaptor should be connected

directly to the TV’s USB port. USB hubs are not

supported. You can plug your wi dongle into the

supplied dock in cases where network quality is poor

and the wi dongle needs to be placed to a location

with better signal quality.

• The Wireless LAN adaptor supports 802.11 a,b,g &

n type modems. It is highly recommended that you

should use the IEEE 802.11n communication protocol

in order to avoid any possible problems while watching

videos.

• Use the other USB input, if you experience problems

with audio/video performance.

• You must change your modem’s SSID when there are

any other modems around with the same SSID. You

can encounter connection problems otherwise. Use

a wired connection if you experience problems with a

wireless connection.

ConguringWirelessDeviceSettings

To enable Wi-Fi features, plug in the Wi-Fi dongle to one

of the USB ports. Open the Network Settings menu

and select Network Type as Wireless Device to start

connection process.

Press the Yellow button to scan the wireless networks.

A list of available networks will be displayed. Please

select your desired network from the list.

Note: If the modem supports N mode, you should set

N mode settngs.

If the selected network is protected with a password,

please enter the correct key by using the virtual

keyboard. You can use this keyboard via the navigation

buttons and the OK button on the remote control.

Wait until the IP address is shown on the screen.

This means that the connection is now established. To

disconnect from a wireless network, highlight Network

Type and press OK.

You can navigate between menu tabs by pressing left/

right buttons. The help bar on the bottom of the dialog

shows features that you may use. Press the Blue

button to check your internet connection speed. Press

the Green button to switch to advanced mode and then

press the OK button to edit settings.

Other Information

Configuration Status: Displays Wi-Fi status as

Connected or Not Connected.

IP Address: Displays the current IP address.

Network Name: Connected networks’ name will be

displayed.

DeleteSavedWi-FiProles

Saved proles will be deleted if you press the Red button

while the wireless device selection OSD is on the screen.

Connecting to your mobile device via WiFi

• If your mobile device has WiFi feature, you can connect

it to your TV via a router, in order to access the content

in your device. For this, your mobile device must have

an appropriate sharing software.

• Connect to your router following the steps stated above

in the Wireless Connectivity section.

• Afterwards, engage your mobile device with the router

and then activate the sharing software on your mobile

device. Then, select les that you want to share with

your TV.

• If the connection is established correctly, you will be

able to access the shared les from your mobile device

via the Media Browser of your TV.

• Enter the Media Browser menu and the playback

device selection OSD will be displayed. Select your

mobile device and press the OK button to continue.

• If available, you can download a virtual remote

controller application from the server of your mobile

device application provider.

Note: This feature may not be supported on all mobile

devices.

Connectivity Troubleshooting

Wireless Network Not Available

• Ensure that any rewalls of your network allow the

TV wireless connection.

• Ensure the “Veezy 200” USB WiFi dongle is plugged

in fully.

• Try searching for wireless networks again, using the

Network Settings menu screen.

If the wireless network does not function properly, try

using the wired network in your home. Refer to the

“Wired Connectivity” section for more information on

the process.

If the TV does not function using the wired connection,

check the modem (router). If the router does not

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Salora 28LED9112CSW in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Salora 28LED9112CSW Manual

Product: