Manual Salora 28LED9112CSW (page 34 of 96) (English, German, Dutch, French)

594914

Zoom out

Zoom in

1/96

English - 56 -

Recording a Programme

IMPORTANT: When using a new USB hard disk drive,

it is recommended that you rst format the disk using

your TV’s “Format Disk” option.

To record a programme, you should rst connect a

USB disk to your TV while the TV is switched off. You

should then switch on the TV to enable the recording

feature.

To use recording your USB drive should have 1 GB

free space and be USB 2.0 compatible. If the USB

drive is not compatible an error message will be

displayed.

Recorded programmes are saved into the connected

USB disk. If desired, you can store/copy recordings

onto a computer; however, these les will not be

available to be played on a computer. You can play

the recordings only via your TV.

Lip Sync delay may occur during the timeshifting.

Radio record is supported. The TV can record

programmes up to ten hours.

Recorded programmes are split into 4GB partitions.

If the writing speed of the connected USB disk is not

sufcient, the recording may fail and the timeshifting

feature may not be available.

It is recommended to use USB hard disk drives for

recording HD programmes.

Do not plug out the USB/HDD during a recording. This

may harm the connected USB/HDD.

Multipartition support is available. A maximum of two

different partitions are supported. The rst partition of

the USB disk is used for PVR ready features. It also

must be formatted as the primary partition to be used

for the PVR ready features.

Some stream packets may not be recorded because

of signal problems, as a result sometimes videos may

freeze during playback.

Record, Play, Pause, Display (for PlayListDialog)

keys can not be used when teletext is ON. If a

recording starts from timer when teletext is ON,

teletext is automatically turned off. Also teletext usage

is disabled when there is an ongoing recording or

playback.

Timeshift Recording

Press Pause button while watching a broadcast to

activate timeshifting mode. In timeshifting mode, the

programme is paused and simultaneously recorded

to the connected USB disk.

Press Play button again to resume the paused

programme from where you stopped. Press the Stop

button to stop timeshift recording and return to the

live broadcast.

Timeshift cannot be used while in radio mode.

You cannot use the timeshift fast reverse feature

before advancing the playback with the fast forward

option.

Instant Recording

Press Record button to start recording an event

instantly while watching a programme. You can

press Record button on the remote control again to

record the next event on the EPG. In this case, an

OSD will be displayed, indicating the programmed

events for recording. Press Stop button to cancel

instant recording.

You can not switch broadcasts or view the Media

Browser during the recording mode. While recording

a programme or during the timeshifting, a warning

message appears on the screen if your USB device

speed is not sufcient.

Watching Recorded Programmes

Select the Recordings Library from the Media

Browser menu. Select a recorded item from the list (if

previously recorded). Press the OK button to view the

Play Options. Select an option then press OK button.

Note: Viewing main menu and menu items will not be available

during the playback.

Press the Stop button to stop a playback and return

to the Recordings Library.

Slow Forward

If you press Pause button while watching recorded

programmes, the slow forward feature will be

available. You can use Rapid advance button to

slow forward. Pressing Rapid advance button

consecutively will change slow forwarding speed.

RecordingConguration

Select the Recording Configuration item in the

Settings menu to congure the recording settings.

Format Disk: You can use the Format Disk feature

for formatting the connected USB disk. Your pin is

required to use the Format Disk feature (default pin

is 0000).

Default PIN code can change depending on the

selected country.

If you are asked to enter a PIN code for viewing a menu

option, use one of the following codes: 4725, 0000 or

1234.

IMPORTANT: Formatting your USB drive will erase

ALL the data on it and it’s le system will be converted

to FAT32. In most cases operation errors will be xed

after a format but you will lose ALL your data.

If “USB is too slow” message is displayed on the

screen while starting a recording, try restarting

the recording. If you still get the same error, it is

possible that your USB disk does not meet the speed

requirements. Try connecting another USB disk.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Salora 28LED9112CSW in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Salora 28LED9112CSW Manual

Product: