459466
26
Zoom out
Zoom in
Previous page
1/28
Next page
• 26 •
Machine Actions Causes Solutions
The machine does not turn on. The machine is not connected to the power
source.
Connect the machine to the power source.
The co ee is not hot enough. The cups are cold. Warm the cups with hot water.
No hot water or steam is dispensed. The hole of the steam wand is clogged. Clean the hole of the steam wand using a pin.
Make sure that the machine is turned off
and has cooled before performing this ope-
ration.
Pannarello is dirty (if supplied). Clean the Pannarello.
The co ee has little crema.
(see note)
The coffee blend is unsuitable, the coffee is not
freshly roasted or the grind is too coarse.
Change co ee blend or adjust the grind as explained
in the “Co ee Grinder Adjustment” section.
The machine takes a long time to warm up
or the amount of water dispensed from the
wand is too little.
The machine circuit is obstructed by limescale
build-up.
Descale the machine.
The brew group does not come out. The brew group is out of place. Turn the machine on. Close the service door. The
brew group automatically returns to the correct
position.
Co ee grounds drawer is inserted. Remove the co ee grounds drawer  rst, then the
brew group.
The machine grinds the co ee beans but no
co ee comes out.
(See note)
Water tank is empty. Fill the water tank and prime the circuit (section
“Using the machine for the first time or after a
long period of inactivity”).
Brew group is dirty. Clean the brew group (section “Brew Group”).
Circuit is not primed. Prime the circuit (section “Using the machine for
the  rst time or after a long period of inactivity”).
Rare event that occurs when the machine is auto-
matically adjusting the dose.
Brew a few co ees as described in section “Saeco
Adapting System.
The dispensing spout is dirty. Clean the dispensing spout.
The co ee is too weak.
(see note)
Rare event that occurs when the machine is auto-
matically adjusting the dose.
Brew a few co ees as described in section “Saeco
Adapting System.
Co ee is brewed slowly.
(see note)
The co ee grind is too  ne. Change coffee blend or adjust the grind as ex-
plained in the “Coffee Grinder Adjustment” sec-
tion.
The circuit is not primed. Prime the circuit (section “Using the machine for
the  rst time or after a long period of inactivity”).
The brew group is dirty. Clean the brew group (section “Brew Group”).
Co ee leaks out of the dispensing spout. The dispensing spout is clogged. Clean the dispensing spout and its holes.
Note: These problems can be considered normal if the co ee blend has been changed or if the machine has just been installed.
In this case wait until the machine performs a self-adjusting operation as described in section “Saeco Adapting System”.
Please contact Saeco Customer Service or an authorized service center for any problems not covered in the above table or
when the suggested solutions do not solve the problem.
TROUBLESHOOTING
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saeco Syntia HD 8836 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saeco Syntia HD 8836 in the language / languages: English as an attachment in your email.

The manual is 3,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Saeco Syntia HD 8836

Saeco Syntia HD 8836 User Manual - German - 28 pages

Saeco Syntia HD 8836 Additional guide - Dutch - 3 pages

Saeco Syntia HD 8836 User Manual - Dutch - 24 pages

Saeco Syntia HD 8836 User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info