362075

Saeco magic de luxe Manual

17
Zoom out
Zoom in
Previous page
1/63
Next page
Do not switch on the machine if the water tank
is empty: always make sure there is enough
water in the tank!
Connect the plug to the socket and press the
main switch.. The energy saving led switches
on, showing that the function is off. If the
energy saving led is blinking, press the button
to disactivate the energy saving mode. The
electronic circuit carries out a self-diagnosis.
This phase could make some noise.
Drainage
Direct the steam/hot water dispensing tube (5)
over the drip tray (2).
Place a cup or another suitable container under
the dispensing tube, then turn the steam/hot
water selection knob (6) counterclockwise.
The pump automatically starts.
Wait until a regular water jet is obtained, then
close the knob. The machine is now drained.
Important: It is advisable to drain the ma-
chine before the first start, after a prolonged use
or whenever the water tank has been com-
pletely emptied.
Furthermore, should temperature or water
tank warning lights blink, drain the machine.
The machine is ready for use as soon
as the temperature light is on.
Programming the machine
27
To enter the programming mode, turn the ma-
chine off with the main switch.
Press steam , espresso coffee and the
main switch at the same time.
25
Coffee bean container (11) is attached with two
screws.
Remove the cover (12) and fill it with coffee beans
(approx. 300 g), then replace the cover.
Adjust grinding by means of the grind adjustment
lever (13), positioning it on point "5" of the scale.
Never fill the coffee bean container with other
products! (They might damage the machine!)
Before filling the container with coffee beans,
make sure the pre-ground coffee container is
closed to prevent coffee grains from falling into
it (they might damage the machine).
Remove the water tank (8) from the machine,
remove its cover (9) and fill it with cold water
(approx. 2.4 l).
A valve on the tank bottom prevents water from
escaping.
Before installing the water tank in the
machine, make sure the coffee bean
container cover is properly fitted.
26
Install the water tank, slightly pressing over it to
fit the valve which will open automatically.
Replace the cover on the tank.
Do not fill the tank with an excessive quantity of
water.
Always fill the tank with fresh water: hot water
as well as other fluids might damage the tank.
31
DRAINAGE
32
RECOMMENDATIONS
Release the buttons.
Water hardness adjustment
In order to adjust the water hardness, it is
necessary to test the water using the strip
supplied with the machine.
Dip the strip into the water for a second, shake
off excess water gently, wait approx. 1 minute
and read the result.
The tall coffee button allows a water
hardness adjustment from 1 to 4.
Each time the key is pressed, the value in-
creases by 1.
As soon as value 4 has been reached, the
counter resets and restarts from 1.
As far as lime scale values are concerned, see
page 37, points 45-48.
Pre-Grinding
The coffee grinder is activated by pressing the
button of the heating plate .
When this button lights up, the coffee grinder
has been activated.
Grinding occurs every time the doser is empty,
thus a ground coffee portion is always ready in
the doser, saving time.
Pre-Infusion
The regular coffee button activates or
disactivates the dispensing of coffee, as shown
by the lit button.
As soon as the coffee has been moistened, the
pump stops for two seconds. Then the brewing
cycle continues.
Coffe dosage adjustment
28
Adjustment lever (19) allows the selection of the
coffee quantity, from 6 to 9 grams.
Open the service door (15) and place the
adjustment lever (19) in the desired position.
Note: Opening the service door causes the
machine to stop automatically. Close the door
to restart the machine.
Coffee dosage must not be changed frequently,
otherwise the coffee dis-
penser may get damaged, thus spoiling the
quality of coffee.
Recommendations
Test
If the machine has not been used for a prolonged
period, it is advisable for hygienic reasons to run
a rinse cycle through the machine.
Place a cup under the dispensing tube (5) and
operate the steam/hot water knob (6). Fill a
cup with water.
Preheating cups
Cups may be preheated by placing them on the
heating plate.
Temperature warning light
When connecting the machine, the green warn-
ing light will light permanently after approx. two
minutes, showing the machine is ready to be
used.
Empty coffee bean container warn-
ing light
When this led is on, the coffee grinder stops.
Fill the container with coffee bean and restart
the cycle.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Saeco magic de luxe at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Saeco magic de luxe in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Saeco magic de luxe

Saeco magic de luxe User Manual - English - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info