EREN BESEITIGUNG @ 0\mod_1115373523343_1521.docx @ 1904 @ 1 @ 1
19TROUBLESHOOTING
Pos: 25.3.1 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/1 Tabellenkopf @ 0\mod_1115374760156_1521.docx @ 1884 @ @ 1
Fault Possible cause Remedy
Pos: 25.3.2 /Innenteil/Störungsursachen und deren Beseitigung/Störung stabellenelemente/Motor springt nicht an E-Start 43er, (fixed speed) Quantum+675EXi, neu SA1855,SA1856 @ 50\mod_1488805276362_1521.docx @ 561877 @ @ 1
Engine does not start
up
Control handle not
turned down.
Press the control handle onto
the upper part of the bar D .
Fuel tank empty. Fill up with clean and fresh
fuel.
Spark plug connector
loose.
Push plug connector in place
or have it checked by an
authorised workshop.
Spark plug defective or
soiled or electrodes worn
out.
Replace or clean spark plug,
set electrode distance Y :
0.5 mm (for model
43-VARIO (SA1455), R43V,
R43VE)
0.7 - 0.8 mm
(for model 43-A ECONOMY,
43-VARIO (SA1855), 43-
VARIO E, R43S).
Too much petrol feed to
engine (spark plug wet).
Have it checked by an
authorised workshop.
Air filter soiled. Clean or replace the air filter
insert W .
Battery not charged (only
for electro-start).
Charge battery W1 , X1 .
Start-up takes longer
than 5 seconds or is
repeated too often
(only for electro-start).
If you experience start
difficulties, contrary to
expectations, the battery
must also be charged in
between.
Connection cable
between the ignition key,
battery and engine is
loose or without contact
(only for electro-start).
Connect the battery
connector with the mating
connector on the harness
U1 or check it or have it
checked by an authorised
workshop.
Pos: 25.3.3 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motorleistung lässt nach @ 33\mod_1408527299785_1521.docx @ 241497 @ @ 1
Engine power
decreasing
Air filter soiled. Clean or replace the air filter
insert W .
Spark plug clogged with
soot.
Have it checked by an
authorised workshop.
Fuel old or soiled Empty the petrol tank and fill
with fresh petrol.
Pos: 25.3.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motor läuft unregelmäßig @ 0\mod_1127909273145_1521.docx @ 1891 @ @ 1
Engine runs irregularly
Air filter dirty. Clean or replace air filter
insert W .
Spark plug contaminated
with soot.
Have it cleaned by an
authorized dealer.
Have it checked by an
authorized dealer.
Pos: 25.3.5 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Mäher fährt nicht (nur bei zuschaltbarem Fahrantrieb) MUSTER @ 17\mod_1334237837356_1521.docx @ 137112 @ @ 1
Mower is not moving
(only with selective
motor drive)
Drive control bar not
pulled.
Pull drive control bar G .
Have it checked by an
authorised workshop.
Pos: 25.3.6 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Fahrgeschwindigkeit kann nicht reguliert werden (nur bei VARIO-Antrieb) MUSTER @ 17\mod_1331728174348_1521.docx @ 134610 @ @ 1
Driving speed cannot
be regulated (only with
VARIO drive)
Have it checked by an
authorised workshop.
Pos: 25.3.7 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabel lenelemente/Starke Erschütterungen (Vibrieren) @ 0\mod_1115377318234_1521.docx @ 1900 @ @ 1
Extreme vibration
Have it checked by an
authorized dealer
Pos: 25.3.8 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabel lenelemente/Schnitt unsauber, Rasen wird gelb, Benzin MUSTER @ 17\mod_1331728299135_1521.docx @ 134627 @ @ 1
Cut not clean,
lawn turns yellow
Cutting blade blunt. Have it sharpened and
balanced by an authorised
workshop Q.
Cutting height too low. Set higher cutting height I .
Motor speed too low. Have it checked by an
authorized dealer
Mowing speed too high. Adapt mowing speed, switch
motor drive off if necessary.
Insufficient overlap
between mowing lanes.
If grass is long, the mowing
lanes may need to overlap
further.
Lawn matted. A perceptible improvement
can be achieved by using a
scarifier.
Pos: 25.3.9 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Auswurf verstopft, Benzin, TurboSignal MUSTER @ 17\mod_1331728502002_1521.docx @ 134644 @ @ 1
Ejector blocked
TurboSignal ignored
J + K .
Empty the collecting bag L .
Engine speed too low. Have it checked by an
authorized dealer
Cutting height too low
with grass too high.
Set higher cutting height I .
Mowing speed too fast. Adapt mowing speed, switch
motor drive off if necessary.
Grass is damp. Allow the lawn to dry.
Pos: 25.3.10 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Gemulchte Gras sieht schlecht aus Heckauswurf MUSTER @ 17\mod_1331728621432_1521.docx @ 134661 @ @ 1
The mulched grass
does not look good:
clumps, excessive cut
material, coarse cut
Cutting blade blunt. Have it sharpened and
balanced by an authorised
workshop.
Mulching rule ignored
(cut max. 1/3 of grass
height; the grass height
to be cut must be less
than 10 cm)
Set higher cutting height I .
Convert mower to rear
ejection U2 + S1 and mow
lawn with high cutting height
first.
Driving speed too high. Adapt driving speed, switch
motor drive off if necessary.
Grass accumulation
under the mower blade.
Set higher cutting height I .
Insufficient overlap
between mowing lanes.
If grass is long, the mowing
lanes may need to overlap
further.
Grass is damp. Set higher cutting height I .
Allow the lawn to dry.
Pos: 25.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungsursachen und deren Beseitigung Text Benzin @ 0\mod_1115378183390_1521.d ocx @ 1905 @ @ 1
In case of faults and defects which have not been listed here, please contact the
nearest authorized dealer.
Repairs which require specialized knowledge should only be performed by a qualified
expert. Your authorized dealer will naturally also be glad to help if you do not wish to
perform the maintenance work described here yourself.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Sabo R43S at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Sabo R43S in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.
The manual is 3,82 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
