661041

Sabo 47-EL VARIO Manual

55
Zoom out
Zoom in
Previous page
1/91
Next page
9
GB
Always have the blade attachment screw tightened by a specialist workshop, since according to the applicable standard DIN
EN 60335, an insulation test must always be carried out following repairs or maintenance work to insulating components
(e.g. blade screws).
Make sure that all safety devices are fitted properly and are not damaged.
9 STARTING THE MACHINE
Safety instruction!
See table for explanation of symbols page 3
IMPORTANT
If the unit is to be operated via a generator, an authorised specialist workshop should first be consulted with regard
to a suitable generator.
Attaching the connecting cable (Illustration C2 )
ATTENTION
In order to ensure the proper and safe use of a garden appliance, a connection cable should be used of a minimum
quality H 05 RN-F to DIN/VDE 0282/4, with a cross-section of 3 x 1 mm² and a rubber or rubber-sheathed
DIN/VDE 0620 connection coupling. The lawnmower must be connected to an earthed socket rated for 230V AC with
a 16 amp slow fuse.
When using a cable with a child safety device, smooth operation of the safety device must be ensured, since
otherwise the connection plug of the appliance may be damaged.
IMPORTANT
Cables with a cross-section of 3 x 1 mm
2
should only be used up to a length of 25 metres. If a connection cable with
a cross-section of 3 x 1.5 mm
2
is used, the length of the connection cable can be up to 40 metres.
– Plug the cable into the switch/plug combination on the upper handle.
– Only then should the connecting cable be connected to the mains.
– When removing the cable always disconnect the cable plug from the mains first.
Attaching the connecting cable to the strain relief fitting (Illustration D2 )
ATTENTION
The unit may not be used without the cable relief in order to prevent damages to the switch/plug combination and to
the cable. The cable must be hung in the cable relief on the mower to ensure that it is fixed safely. This prevents the
cable socket from being pulled off the mower. Moreover, the cable aligns itself automatically on the other side when
cornering.
– When forming a semi-circular loop for hanging the cable, keep a distance of approx. 80 cm from the connection cable
coupling.
– Insert the loop from the bottom into the cable relief and tie it around a fastening web (1).
– Hold the cable by both ends and pull it firmly into the cable relief.
– To release the cable, push the loop upwards from both sides until it can be pulled away from the rear of the web and
hence removed from the cable relief.
Starting the motor (Illustration A2 )
Only start the engine when standing behind of the mower.
Place the mower on a level surface where the grass is not too high (high grass inhibits the start of the cutter bar and makes
starting more difficult). Where this is not possible, position the mower in such a way that the cutter is facing diagonally away
from the user, although only as far as absolutely necessary.
– To switch on the motor, first press and hold the red button (1).
– With the other hand, pull the red safety grip (2) on the upper handlebar section. The grip must be held in this position
during operation.
– The red button can then be released.
IMPORTANT
If the motor does not start 5 seconds after the unit is started, then
1. Let go of the switch holder
2. Pull the plug!
3. Check the power cable
4. Check the power supply at the building (fuse)
5. Check the unit for blockages in the mowing chamber
6 Get it checked by an authorised specialist workshop.
… 55 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sabo 47-EL VARIO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sabo 47-EL VARIO in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info