628373

SAB Heli Division Goblin 770 Manual

28
Zoom out
Zoom in
Previous page
1/48
Next page
DE-BURR THE SIDE FRAMES
We recommend de-burring the edges of the carbon parts in areas where electrical wires run.
ESC INSTALLATION
There are two mounting options:
Mount using part # H0004 (ESC Aluminum Support)
Typically used for Kontronik Jive 120. The speed controller is placed on top of the aluminum support. (Fig. 1)
Mount using part #H0153 (ESC Carbon Support) (Fig. 2)
Typically used for ESCs with aluminum cases, such as Kontronik Kosmik (Fig. 3). The speed controller is attached under the
carbon fiber plate.
A heat sink upgrade is available for the YGE 160 controller (Part #H0165-S) (Fig. 4)
Figure 5
: Shows the wiring which connects the receiver and ESC (in this picture one frame has been removed).
If the BEC used is combined with the ESC, it is recommended to use a dual wire connection.
Figure 6
: The passage of the controller wires to the motor is highlighted.
Figure 7
: Shows the installation of a 2S battery for the flight control system.
Alternatively, a BEC could be placed in the same area.
ESC Cables
2S Battery or BEC
Copyright@2012 - SAB Heli Division - All rights reserved
Page 26
Chapter 10, Installation Of The ESC
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SAB Heli Division Goblin 770 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SAB Heli Division Goblin 770 in the language / languages: English as an attachment in your email.

The manual is 66,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info