628373
24
Zoom out
Zoom in
Previous page
1/48
Next page
Socket Head Cap Screw M2.5x12mm
Tail Servo Assembly
The tail servo wire lead should be secured with hot
glue in the area indicated by the arrow (figure 1).
Figure 2 shows the installed servo.
Note: Please note that the boom edges might
be rough and can eventually chafe or cut your tail
servo lead - we recommend protecting the leads with
heat shrink or even electrical tape.
Tail Assembly
B
DETAIL B
SCALE 1 : 3.3
Servo Spacer
(H0075-S)
Carbon Rod Assembly
(HC238-S)
Socket Head Cap Screw
M2x6mm
(HC004-S)
Tail Servo Assembly
......
x4
Socket Head Cap Screw
M2.5x12mm
......
x1
Socket Head Cap Screw
M2x6mm
......
x1
Uniball M2
5H6
15-16mm
The distance between the
axis and the ball must be
between 15-16 mm
Uniball M2
5H6
(H0064-S)
Tail Servo
Copyright@2012 - SAB Heli Division - All rights reserved
Page 22
Chapter 7, Tail Servo Installation
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SAB Heli Division Goblin 770 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SAB Heli Division Goblin 770 in the language / languages: English as an attachment in your email.

The manual is 66,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info