628357

SAB Heli Division GOBLIN 630 COMPETITION Manual

35
Zoom out
Zoom in
Previous page
1/48
Next page
MAINTENANCE
*On the Goblin, areas to look for wear include:
* Motor belt
* Tail belt
* Damper
* Main gear and pinion
The lifespan of these components varies according to the type of flying. On average it is recommended to replace
these special parts every
100
flights.
*The head tends to lose rigidity after a while. Check this condition every
20
flights. Preloading with precision shim washers,
it is possible to vary the rigidity of the head.
*Check all uniballs often.
*The most stressed bearings are definitely those of the tail shaft. Check them frequently.
All other parts are not particularly subject to wear.
*Periodically lubricate the tail slide movement and its linkages as well as the swashplate movement and its linkages.
*Lubricate the main gear with silicone and Tri-Flow Synthetic grease, even though the gear is made of technopolymer,
a high mineral based filler, it still requires some lubrication.
*Check the screws that are highlighted in the following images frequently, make sure you remain tight (
fig.2
and
fig.3
).
*To ensure safety you should do a general inspection of the helicopter after each flight. You should check:
* The maintenance of proper belt tension.
* The proper isolation of wires from the carbon and aluminum parts.
* That all screws remain tight.
HPS HEAD
- The dampening system of this head allows for a wide range of head speeds to be used without sacriticing safety.
- The dampers are composed of an o-ring and a technopolymer damper that defines the maximum possible movement of
the spindle.
- The model response with change based on the preload, less preload (less shims) will allow for a softer feel and lower head
speed, a high preload is used for hard 3D flight.
- To increase the preload, you can add an additional 0.2mm shim on each side, to decrease the preload, you can remove a
0.2mm shim on each side. It is important that the blade grips do not have the axial play so you must always keep the 1mm
shim on each side regardless.
Copyright@2013 - SAB Heli Division - All rights reserved
Page 33
Chapter 16, Maintenance
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SAB Heli Division GOBLIN 630 COMPETITION at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SAB Heli Division GOBLIN 630 COMPETITION in the language / languages: English as an attachment in your email.

The manual is 56,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of SAB Heli Division GOBLIN 630 COMPETITION

SAB Heli Division GOBLIN 630 COMPETITION Additional guide - English - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info