628357
19
Zoom out
Zoom in
Previous page
1/48
Next page
ASSEMBLY OF THE BALL ON THE HORN.
The rods going from the servos to the swash plate must be as vertical
as possible. Not all servos are equal, so to better align them you can
choose to use the supplied spacer H0031. Figure 4 illustrates this.
INSTALLATION OF SWASHPLATE SERVOS
The linkage ball must be positioned between
17-19 mm
out on the servo arm (
figure 1
). The 120° placement of the servos inside Goblin means
the arms are difficult to access. For this reason it is advisable to ensure alignment of the servo arms (and sub trim set) before installation of
the servos in the model (
figure 2
). Proceed with installation following the instructions below.
Figure 3
shows a completed installation.
Uniball M2
5H6
(H0064-S)
Socket Head Cap Screw M2x8mm
(HC008-S)
or
Socket Head Cap Screw M2x6mm
(HC004-S) without Uniball Spacer
..... x3
Socket Head Cap Screw
M2.5x8mm
Servo 2
SERVO ASSEMBLY 1, 2, 3
Servo 1
Uniball Spacer
(H0064-S)
Socket Head Cap
Screw M2.5x12mm
(HC026-S)
..... x9
Socket Head Cap Screw
M2.5x12mm
Socket Head Cap Screw
M3x6mm
(HC044-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Servo 1
Servo 3
Servo Spacer
(H0075-S)
Servo 2
Servo 3
17-19mm
Copyright@2012 - SAB Heli Division - All rights reserved
Page 17
Chapter 8, Installation Of Swashplate Servos
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SAB Heli Division GOBLIN 630 COMPETITION at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SAB Heli Division GOBLIN 630 COMPETITION in the language / languages: English as an attachment in your email.

The manual is 56,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of SAB Heli Division GOBLIN 630 COMPETITION

SAB Heli Division GOBLIN 630 COMPETITION Additional guide - English - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info