628350

SAB Heli Division Goblin 570 Manual

19
Zoom out
Zoom in
Previous page
1/40
Next page
5mm
2.5 mm
2.5 mm
Motor Belt Tension
- Install the motor and pulley to the motor mount plate.
- Place the motor assembly in position.
- Compress the springs by pushing the motor towards the main shaft.
- At max compression, tighten one of the slide screws temporarily.
- Put the belt around the motor pulley first, then put it around the big pulley.
- Rotate the motor a few times by hand to allow the belt to site properly.
- Loosen up the slide screw; the springs will tension the belt.
- Help the springs by pulling the motor and tighten.
- The belt must be very tight.
- Make sure to tighten all screws and nuts.
Figure 1 shows the correct wiring for the motor. We recommend to use heat shrink in the joins between the motor and the ESC wires.
Check for proper vertical alignment of the motor pulley. Simply turn the motor several times by hand in the direction of normal rotation
(counter clock-wise when viewed from above) and check to see if the belt is aligned with the big pulley. If the belt is riding too high, simply
loosen up the motor pulley and drop it a bit, if it is riding too low, loosen up the motor pulley and raise it a bit (Fig 2 - 3).
Motor
Assembly
INCORRECT
Motor Belt
(HC346-S)
CORRECT
Copyright © 2014 - SAB Heli Division - All rights reserved
Page 17
Chapter 9, Installation Of The Motor
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SAB Heli Division Goblin 570 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SAB Heli Division Goblin 570 in the language / languages: English as an attachment in your email.

The manual is 29,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info