628346
13
Zoom out
Zoom in
Previous page
1/40
Next page
2
Socket Head Cap
Screw M2.5x12mm
(HC026-S)
13-15mm
SERVO ASSEMBLY 1, 2, 3
Servo 1
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
Uniball M2
(H0538-S)
INSTALLATION OF SWASHPLATE SERVOS
The linkage ball must be positioned approximately
13-15 mm
out on the servo arm (
figure 1
), it is recommended to use the SAB
servo arm p/n [HA052]. Because of the 120° placement of the servos in the Goblin, the arms are difficult to access. For this reason
it is advisable to ensure alignment of the servo arms (and sub trim) before installation of the servos in the model
(figure 2)
.
Proceed with installation following the instructions below
. Figure 3
shows a completed installation.
The rods going from the servos to the swash plate must be as vertical as possible. ( Red line in Figure 4 )
Not all servos are equal,
so for proper alignment you can choose to use the supplied
spacer H0566 under the uniball H0538.
Bag 6
Servo 2
Servo Spacer
(H0075-S)
Servo 2
Button Head Cap
Screw M2x5mm
(HC005-S)
SAB Servo Arm
(HA052-S) ( Option)
Servo 3
Button Head Cap
Screw M2x5mm
(HC005-S)
Note:
Do not over tighten,
be careful to not strip plastic.
Note:
Do not over tighten,
be careful to not strip plastic.
Page 11
Chapter 8, Installation Of Swashplate Servos
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SAB Heli Division GOBLIN 380 KYLE STACY EDITION at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SAB Heli Division GOBLIN 380 KYLE STACY EDITION in the language / languages: English as an attachment in your email.

The manual is 72,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info