557216
16
Zoom out
Zoom in
Previous page
1/25
Next page
16
OPERATION
Grasp recoil starter and pull slowly until resistance is felt.
Give recoil starter a short, brisk pull to start the engine.
Do not allow the recoil starter to snap back after starting;
return it gently to its original place.
NOTE: If engine does not start after several pulls, depress
trigger to release pressure then repeat normal starting
procedure.
Let engine run for several seconds, then push choke in.
To stop the engine:
Put the engine switch in the OFF position.
Turn the fuel valve to the OFF position.
Push up on the lock out until it clicks into the slot.
USING THE SPRAY WAND TRIGGER
See Figures 19 - 20.
For greater control and safety, keep both hands on the
trigger handle at all times.
Pull back and hold the trigger to operate the pressure
washer.
Release the trigger to stop the flow of water through the
nozzle.
To engage the lock out:
Push up on the lock out until it clicks into the slot.
To disengage the lock out:
Push the lock out down and into its original position.
For the most effective cleaning, the spray nozzle should be
between 20 cm and 60 cm from the surface to be cleaned. If
the spray is too close it can damage the cleaning surface.
SELECTING THE RIGHT QUICK-CONNECT
NOZZLE FOR THE JOB
See Figure 21.
Before starting any cleaning job, determine the best nozzle
for the job. Each of the nozzles has a different spray
pattern. The nozzle patterns are: 25° (for general purpose
or large surfaces), 15° (for tough jobs), 0° (for spot cleaning
or hard-to-reach areas), and the Soap Blaster
nozzle (for
long and short range detergent application).
WARNING:
NEVER change nozzles without locking the lock out on
the trigger handle and NEVER point the wand at your
face or at others. The quick-connect feature contains
small springs that could eject the nozzle with some force.
Failure to heed this may cause personal injury.
Using the quick-connect collar, changing nozzles is easy.
To connect a nozzle to the trigger handle:
Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
Fig. 20
Fig. 21
NOZZLE
QUICK-CONNECT
COLLAR
SPRAY
WAND
“CLICK”
LONG RANGE
DETERGENT
APPLICATION
SHORT RANGE
DETERGENT
APPLICATION
SOAP
BLASTER™
Fig. 19
SLOT
LOCK OUT
TRIGGER
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ryobi RPW2500WB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ryobi RPW2500WB in the language / languages: English as an attachment in your email.

The manual is 8,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info