649845

Russell Hobbs 23490 Aura Manual

8
Zoom out
Zoom in
Previous page
1/176
Next page
8
Fitting the bowl
Raise the arm before fitting or removing the bowl. Use only the bowl supplied.
1. Fit the bowl into the recess in the base and turn it clockwise until it locks.
2. To remove, turn it anti-clockwise then lift it off the base.
Fitting/removing attachments
Switch off, unplug and raise the arm before fitting or removing attachments.
1. Align the slot in the attachment with the pin on the drive shaft (Fig A).
2. Push the attachment onto the drive shaft then turn it anti-clockwise to lock it (Fig B).
To remove an attachment, push it upwards slightly then turn it clockwise and pull it off the shaft.
Splash guard
The splash guard protects you from spills or splashes during mixing while still allowing you to add
ingredients. Switch off and unplug your mixer before fitting/removing the splash guard.
With the bowl in position and the arm in the lowered position:
1. Slide the splash guard between the arm and the bowl.
2. Align it so that the opening is on the right hand side (Fig C).
• Always remove the splash guard before raising the arm.
USING YOUR MIXER
1. Check that the speed control is set to O.
2. Put the plug into the power socket (switch the socket on, if its switchable).
3. Turn the speed control clockwise to the speed you want.
4. The range is from 1 (low) to 10 (high). Turn the speed control back to O to turn the motor off.
5. To operate the motor in short bursts, turn the speed control to the Y position. Release the control to
stop the motor.
Recommended Speeds
Attachment Speed Use for
Whisk 7-10 beating/aerating cream, egg whites, batter, light mixes
Beater 4-7 creaming butter and sugar, medium cake mixes
Dough hook 1-3 heavy mixtures, bread, pastry
BLENDER
ASSEMBLY
1. Slide off the blending jug drive cover (Fig D).
2. Insert the jug into the drive opening with the t mark on the jug aligned with the Umark
on the mixer (Fig E).
3. Twist the jug clockwise until the t mark on the jug is aligned with the Lmark on the mixer
(Fig F).
4. Add the ingredients to the the jug and fit the lid and cap (Fig G). Don’t fill past the max
mark on the jug. Never use the jug without the lid fitted.
USING YOUR BLENDER
1. Check that the speed control is set to O.
2. Put the plug into the power socket (switch the socket on, if its switchable).
3. Turn the speed control clockwise to the speed you want.
4. The range is from 1 (low) to 10 (high). Turn the speed control back to O to turn the motor off.
5. To operate the motor in short bursts, turn the speed control to the Y position. Release the control to
stop the motor.
6. If you need to add other ingredients during blending, turn the cap anticlockwise and lift it off. Add
the ingredients then replace the cap and turn it clockwise to lock it.
7. When you have finished blending, turn the speed control to O and wait for the blades to stop before
removing the lid from the jug or the jug from the mixer.
8. To remove the jug, twist it anticlockwise until the
t
mark is aligned with the
U
mark.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Russell Hobbs 23490 Aura at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Russell Hobbs 23490 Aura in the language / languages: All languages as an attachment in your email.

The manual is 2,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info