filling
warning keep clear, steam may escape from the lid.
4 Remove the kettle from the stand.
5 Pull the lid open.
6 Fill with at least 2 cups of water, but not above max
7 If you overfill, the kettle may spit boiling water.
8 Close the lid, and press it down to close.
9 Check the lid is closed, or the kettle won’t switch off when it boils.
switching on
10 Plug the stand into the wall socket.
11 Put the kettle on the stand – take care not to spill.
12 Move the switch down to 1.
13 The light will come on, and the kettle will heat up.
switching off
14 When the water boils the kettle will switch off and the light will go out.
15 To switch off manually, move the switch up to 0.
16 Lifting the kettle off the stand will also switch the kettle off.
general
17 Remove the kettle from the stand before pouring.
18 To avoid the risk of splashing, pour slowly and don’t over-tilt the kettle.
19 Don’t tilt the kettle backwards, water might get on to the control area. If this
happens, let the kettle dry before use – sit it somewhere warm for 12 hours.
20 When you lift the kettle, you may see moisture on the stand. Don’t worry – it’s the
steam used to switch off automatically, which then condenses and escapes via vents
under the kettle.
21 You may see some discolouration on the floor of the kettle. Again, don’t worry – it’s
due to the bonding of the element to the kettle floor.
using with insufficient water
22 This will shorten the life of the element. A boil-dry cut-out will switch the kettle off.
23 To prevent the kettle cycling on and off, remove the kettle from the stand and let it
cool before replacing it on the stand.
24 Sit the kettle on the work surface till it’s cold.
25 Don’t fill the kettle till it’s cold, or it may spit.
