3
Read the instructions and keep them safe.
If you pass the kettle on, pass on the instructions too.
Remove all packaging, but keep it till you know the kettle works.
important safeguards
Follow basic safety precautions, including:
1 This kettle must only be used by or under the supervision of a responsible adult.
2 Don’t put the kettle, stand, cable, or plug in any liquid; don’t use the kettle
in a bathroom, near water, or outdoors.
3 Don’t touch hot surfaces. Use the handle.
4 Don’t use the kettle without the filter in place – it may spit boiling water – it may not
switch off.
5 Don’t open the lid while the water is heating.
6 Take care when pouring – pour slowly, and don’t over-tilt the kettle.
7 The scald hazard lasts long after boiling. Keep the kettle, stand, and cable away from
the edges of worktops and out of reach of children.
8 Route the cable so it doesn’t overhang, and can’t be tripped over or caught.
9 Wind excess cable beneath the stand.
10 Unplug the stand when not in use, before moving and before cleaning. Let the
kettle cool down before cleaning and storing away.
11 Check the lid is fully closed before switching the kettle on, otherwise it may not
switch off.
12 Check the kettle is properly located on the stand before switching on.
13 Don’t switch on unless the kettle contains at least 2 cups of water.
14 Don’t fill past max, or it may spit boiling water.
15 Check that the kettle has switched off automatically, or move the switch to 0, to
switch it off manually, before removing it from its stand.
16 Remove the kettle from its stand before filling or pouring.
17 Keep the kettle, stand, cable, and plug away from sources of heat.
18 Don’t use the kettle for any purpose other than heating water.
19 Use the kettle only with the stand supplied (and vice versa).
20 This kettle must not be operated by an external timer or remote control system.
21 Don’t operate the kettle if it’s damaged or malfunctions.
22 If the cable is damaged, the kettle must be returned, in order to avoid hazard.
household use only
before using for the first time
1 Fill to max, boil, discard the water, then rinse it out, to remove manufacturing dust,
etc.
positioning
2 Put the stand on a stable, level surface. Route the cable so it doesn’t overhang, and
can’t be caught or tripped over.
3 Wind excess cable beneath the stand
