705900

Russel Hobbs 25170-56 Manual

6
Zoom out
Zoom in
Previous page
1/96
Next page
6
USING  FROZEN SORBET
Prepare the ingredients before use.
• Do not try to process ingredients that are frozen solid. Allow them to thaw suciently so that a fork
can be inserted into the centre of the ingredient.
• Feed ingredients slowly.
• Do not use excessive force to push the ingredients through the machine.
• Only use the frozen sorbet attachment when making sorbet. Do not t it when juicing.
1. Follow the instructions under ASSEMBLY but t the frozen sorbet attachment at step 2.
2. Process the ingredients as you would when juicing them bearing in mind the above points.
TROUBLESHOOTING
Juicer Stops Operating or Becomes Stuck
1. Set the switch to O.
2. Press the reset button
r
at the rear of appliance.
3. Press and hold the switch in the
R
position for few seconds then try operating again.
4. If the reverse
R
function does not work, turn your juicer o, disassemble and clean it then
reassemble it.
5. After reassembly try operating your juicer again.
Diculty in Disassembling
• In order to disassemble your juicer more easily, run it without any ingredients in for about 30 seconds
after use.
• If the upper container cover cannot be removed easily, try running your juicer in the following way
two or three times:
1. Move the switch from
R
to O to I. With the upper container cover latch in the open position, grasp
the upper container and twist it back and forth until it comes free.
2. If the grinding head becomes stuck, invert the upper container and gently push out the grinding
head from below.
CLEANING
• Run your juicer without any ingredients in for about 30 seconds after use. Add a little warm water
while it is running to aid disassembly.
1. Switch the appliance o (O) and unplug it.
2. Disassemble the appliance.
3. Wipe the outside of the motor unit with a clean damp cloth.
4. Wash the removable parts in warm soapy water, rinse well, drain, and air dry.
5. Use the pointed end of the supplied cleaning brush to help clean places that are more dicult to
reach.
6. Open the rubber ap to access the juice spout tube. See gure J for the location of the rubber ap.
Close the ap properly after cleaning.
` You may wash these parts in a dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will aect the surface nishes.
Damage should be cosmetic only, and should not aect the operation of the appliance.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate ocial recycling/collection point.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Russel Hobbs 25170-56 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Russel Hobbs 25170-56 in the language / languages: All languages as an attachment in your email.

The manual is 1,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info