8
TYPE LH22N LH22EN LH232N LH31N LH32EN
PROTECTION CLASS II II II II II
OPERATING VOLTAGE 230 V-50 Hz 230 V-50 Hz 230 V-50 Hz 230 V-50 Hz 230 V-50 Hz
ABSORBED CURRENT 4,9 A 4,9 A 5,8 A 5,8 A 5,8 A
ABSORBED POWER 1020 W 1020 W 1200 W 1200 W 1200 W
ELECTRONIC OVERLOAD PROTECTION NO YES NO NO YES
ELECTRONIC SPEED CONTROL NO YES NO NO YES
ROTATION RPM 2000 950÷2000 1600÷3400 3400 1400÷3400
MECHANICAL SPEED CONTROL NO NO YES* NO NO
ABRASIVE DISC DIAMETER mm — — 178 178 178
BUFFER DIAMETER MAX mm 200 200 200 — —
SPINDLE THREAD M14 M14 M14 M14 M14
WEIGHT Kg 3,3 3,3 3,7 3,3 3,3
TECHNICAL DATA ENGLISH
GENERAL WARNINGS
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
The safety and accident prevention instructions are reported in the
“SAFETY INSTRUCTION” booklet which forms an integral part of
these documents; the operating instructions indicate the additional
information required specifically for use of the tool.
Never use the tools without the safety guards.
Any operations carried out on the tool must be effected with the power
supply disconnected.
Before starting the tool, ensure that it is held tightly and not in contact
with the work surface.
Wear clothing suited to the work you are about to perform.
Hazardous dust may form during polishing/sanding: use regulation
safety devices for personal protection and observe safety norms valid
for the processed work material.
Due to risks that may arise during polishing/sanding, we recommend
the constant use of P.S.D. (personal safety devices such as gloves,
headphones, goggles, face masks, etc.) according to laws in force to
prevent or reduce accident probability.
Warning! the appliance continues to work for a few seconds after it
has been switched off!
CORRECT USAGE
The tools must only be used for polishing/sanding painted surfaces.
The machine must not be operated in humid environments or in the
presence of flammable gas or liquids.
Before use make sure that the buffer pad/abrasive disc work speci-
fications are compatible to the tool and are not broken or worn. Make
sure they are assembled, handled and stored with care according to
the manufacturer's instructions.
Make sure the work piece is sufficiently fastened.
The user bears sole responsibility for any damage or accidents
resulting from incorrect use.
*obtained by changing the position of the spindle as explained in the instructions
8
