6
REMOTE CONTROL MOD. VU6050
The remote control buttons are the same as those on the appliance control panel.
The information is sent to the appliance by means of an infrared transmission LED located on
the front of the remote control. The infrared receiver is located on the fan control panel.
Do not scratch or cover the transmission LED, or the infrared receiver on the fan.
To use the remote control, point the transmission LED towards the infrared receiver on the fan
and press the required button.
Ensure that there are no obstacles between the transmission LED and the receiver.
The maximum range is approximately 6 metres opposite the fan.
Remote control power:
The remote control is powered by two AAA or LR03 type alkaline batteries, which are not supplied.
Insert the batteries into the battery housing, respecting the battery polarity as indicated in the
housing.
Whenever a command is issued to the control panel, the fan beeps.
IMPORTANT:
It is recommended that you unplug your appliance whenever it is not in use.
CLEANING
• Your appliance must be unplugged before proceeding with any cleaning work.
• You can clean it with a slightly damp cloth.
• IMPORTANT: Never use abrasive products which might damage the appearance of your applian-
ce.
STORAGE
• When you are not using your appliance, store it in a dry place.
• When storing the appliance over a period of time, remove the batteries from the remote control
(mod. VU6050).
GB
• "D" button:
- Press the "D" button once; the appliance starts up at speed 1 and indicator comes on.
- Press the "D" button a second time; the appliance changes to speed 2 and indicator comes on.
- Press the "D" button a third time, the appliance changes to speed 3 and indicator comes on.
- If you press the "D" button again, the appliance changes back to speed 1 and indicator comes on.
• "E" button, immediate appliance shutdown:
- Press the "E" button to completely shut down the appliance.
Pre-select the start-up speed according to your needs (see table above), then select
REDUCTION mode or VARIATION mode (using method described below):
- Press the "C" button once; "VARIATION" mode is activated and the "VARIATION" indicator
comes on.
- Press the "C" button again; "REDUCTION" mode is activated and the "REDUCTION" indicator
comes on.
- Press the "C" button again to stop this function.