739969
9
Zoom out
Zoom in
Previous page
1/60
Next page
5
It is essential that you read these instructions and observe the following recommendations
1 - WARNINGS
• For your safety, this appliance complies with the applicable standards and regulations or commercial (Low Voltage, Electromagnetic Compatibility,
E
nvironmental Directives, etc.)
• The warranty will be invalid in the event of damage arising from incorrect use.
Do not place your appliance immediately below a socket outlet.
• Do not operate your appliance in a dusty room or if there is a risk of fire.
Each time before use, check that in general the appliance is in good condition, as well as the plug and the cord.
• Never insert any objects inside the appliance (e.g.: needles)
If the power cord is damaged, it must be changed by the manufacturer, the After Sales Service or a similarly qualified person in order to avoid any danger.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and know-
l
edge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be
s
upervised to ensure that they do not play with the appliance.
Do not pull the power cord or the appliance, even to unplug it from the wall socket.
Completely unwind the cord each time before use.
• This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer
a
ccepts no responsibility and the guarantee will not apply.
2 - VERY IMPORTANT
WARNING : IN ORDER TO AVOID OVERHEATING DO NOT COVER THE HEATER
Do not touch the appliance with wet hands.
• Do not use the appliance in damp places.
Do not let water get into the appliance.
• Do not use this appliance near baths, showers, sinks or swimming pools.
Do not use the appliance near inflammable objects and products (curtains, aerosols, solvents, etc.).
• Do not use the appliance when tilted or laid flat.
In the event of prolonged absence: stop the appliance using button B and unplug.
Never use the appliance without its filter.
However, the electrical installation in the room, the installation of the unit and the way the unit is used must all comply with the safety standards in force in your country.
3 - VOLTAGE
• Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted to the
p
ower level indicated.
• Your appliance can be used with a power plug without an earth connection. It is a class II appliance (double insulation ).
4 - SAFETY
• In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once it has cooled. If the fault persists
or gets worse, a thermal fuse shuts the appliance down completely and it must then be taken to an approved service centre.
5 - OPERATION
Before turning the unit on, make sure:
• it is positioned as described in these instructions,
• that it is placed on a flat and horizontal surface, and;
• that the air intake and outlet grilles are free of all obstacles.
When the appliance is connected to the mains electricity (plugged in), it is in “STANDBY” mode (Stop), button C is lit; electrical consumption of the appliance
in standby is then less than 0.5W.
The appliance will emit a sound signal each time the control buttons are used.
Display A1: Room temperature at the appliance.
Display A2: Selected temperature.
A3 buttons: temperature selection
(in SILENCE and MAX functions).
Button B “STANDBY”: On / Standby
This button enables you to activate the appliance or switch to standby.
PLEASE NOTE: Whenever you switch it on, the appliance will function for about 1 minute
(without adjusting) whatever the temperature in your room.
A cooling cycle lasting for a few seconds is automatically activated before the appliance
switches off; the button will flash during this cooling cycle.
Button A4 “Cool Fan”: Cold ventilation setting
This setting enables you to use your fan heater as a cooling fan in summer.
Button A5 “SILENCE”: 1000W regulated “Silence setting
This setting enables you to automatically maintain the room temperature at the temperature you have selected using the + and buttons (in a nor-
mally insulated room whose volume corresponds to the power of this function).
Button A6 “MAX”: 2000W regulated setting
This setting enables you to automatically maintain the room temperature at the temperature you have selected using the + and buttons (in a nor-
mally insulated room whose volume corresponds to the power of this function).
EN
A
1
A7
A
2
A
4
A
5
A
6
B/C
A3
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rowenta SO9075 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rowenta SO9075 in the language / languages: All languages as an attachment in your email.

The manual is 9,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info