762561

Rowenta RO2719 Manual

15
Zoom out
Zoom in
Previous page
1/158
Next page
11
EN
* According to model : this piece or accessory is specific to
certain models or can be bought separately.
REMOVE THE DUST TRAY (13)
• Withdraw the tube (19) from the vacuum opening (10) - Fig.2.
• Remove the dust tray (13) from its housing (7) : take the tray handle (13a) and remove the tray – fig. 14.
1. EMPTY THE DUST TRAY
• Press on the opening lever (13c) – fig. 15a—and then remove the lid – fig. 15b.
• Empty the tray over a bin – Fig. 16.
• Make sure that no dust remains inside the tray.
• Place the lid back: place the stops in their slots – fig. 17a – and close the lid – fig. 17b.
• Replace the tray (13) in its compartment (7) – Fig. 18.
2. CLEANING THE BLACK FOAM FILTER (14A)
• Pull simultaneously on the opening clips (13d) of the HEPA filter case - Fig.19.
• Separate the black foam filter (14a) from the HEPA filter (14b) - Fig. 20.
• Wash the black foam filter (14a) under the tap, squeeze it out like a sponge and leave to dry for 12 hours
- fig. 21.
• Once the foam is completely dry, assemble the HEPA filter case (14): black foam filter (14a) and HEPA fil-
ter (14b) under the dust tray (13) – Fig. 22, then replace the dust tray inside its compartment (7) – Fig. 18.
3. CLEAN THE DUST TRAY (13) AND THE AIR/DUST SEPARATOR (15)
• Press on the opening lever (13c) – fig. 15a—and then remove the lid – fig. 15b.
• Empty the tray over a bin – Fig. 23.
• Unlock the HEPA filter case (14) by simultaneously pulling on the opening clips (13d) located at either
end of the dust tray – Fig. 24.
• Remove the HEPA filter case (14) – Fig. 25.
• Turn the compartment over and place the accessory (18b) into the lock slot of the air/dust separator base
(17) - fig 26.
• Open, making sure to turn in the proper sense for unlocking ( ) – Fig.27.
• Remove the dust separator base (16) - Fig. 28.
• Unclip then remove the air/dust separator (15) by turning it in the unlocking direction ( ) – Fig.29.
• Then rinse the dust tray (13), the air/dust separator base (16) and the air/dust separator (15) with soapy
water – Fig. 30.
• Dry them with a cloth – Fig. 31.
• Once dry, replace then clip the air/dust separator (15) on the air/dust separator base (16), following the
right sense for locking ( ) – Fig.32.
• Place them back on the dust tray (13) - fig 33.
• Place the accessory (18b) into the lock slot of the air/dust separator base (16) - fig 34.
• Close, making sure to turn in the proper sense for locking ( ) – Fig.35.
• Clip the HEPA filter case (14) (black foam filter (14a) + HEPA filter (14b)) onto the tray – Fig. 36.
• Replace the tray (13) in its compartment (7) – Fig. 18.
Important! To optimise the performance of your vacuum cleaner, make sure you clean the foam (14a)
each time you empty the dust tray (13).
Warning!
The black foam filter (14a) should only be put back into the appliance when it is completely dry. You
can use your vacuum cleaner while the black foam filter (14a) is drying by using the replacement
black foam filter (14abis).
Important: Clean the dust tray (13) and the dust separator (15) every month.
Important: Empty the dust tray (13) after each use.
Warning: remember to stand over a bin every time you clean the dust tray.
RO_ASPIRATEUR_CITY_SPACE_903359_903359/01 12/06/13 15:34 Page11
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rowenta RO2719 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rowenta RO2719 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 2,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info