483581
7
Zoom out
Zoom in
Previous page
1/7
Next page
4
Important:
If the appliance has been standing unused for long periods, hold it
horizontally and allow it to emit steam for 1 minute to clean the
steam ducts and remove any residue from the iron.
Problems?
If you have any further problems or queries with our products please
call our Customer Relations Team first for expert help and advice:
HELPLINE: 0845 602 1454 – UK (01) 4751947 – Ireland
Or consult our website: www.rowenta.uk
In line with a policy of continuous product improvement Rowenta
reserves the rights to change product specifications without prior
notice.
Problem
No power supply.
The temperature con-
trol is on position “0”
or set too low.
This is normal.
The steam control is
set on position .
There is insufficient
water in the tank.
The Anti-Drip function
is active (depending
on model).
You are using chemi-
cal descaling agents.
Pure distilled/demine-
ralised or softened
water is being used.
Your linen is not rin-
sed sufficiently or
your have ironed a
new garment before
washing it.
You are using a too
high temperature.
You are using starch.
Overuse of extra long
shot of steam button
You have placed your
iron flat on a metallic
rest plate.
You have ironed over
a zip.
Check that the mains plug is
properly inserted or try plug-
ging the iron into a different
socket.
Turn the temperature control
to the required setting.
When the thermostat light goes
on and off, the iron is heating
up. As soon as the light goes
off, the steam temperature has
been reached.
Turn the steam control to the
required setting area.
Fill the tank (C).
Wait for the soleplate to reach
the correct temperature.
Do not add any descaling
agents to the water in the
water tank.
Only use untreated tap water
or mix half tap water with half
distilled/demineralised water.
Ensure linen is rinsed thoroug-
hly to remove any soap depo-
sits or chemicals on new gar-
ments which may be sucked
up by the iron.
See the temperature table to
correctly set the thermostat.
Clean the soleplate as indicated
in section H. Always spray starch
onto the reverse side of the fabric
to be ironed.
Allow more time between
each burst.
Always set the iron on its
heel.
Try to avoid ironing over zips
which may have rough edges.
Possible cause Solution
The soleplate
does not heat up
or the thermostat
light does not
come on.
Thermostat light
goes on and off.
None or too little
steam is being
emitted.
Brown streaks
come through
the holes in the
soleplate and
stain the fabric.
The soleplate is
dirty or brown
and can stain the
linen.
Iron is leaking.
The soleplate is
scratched or
damaged.
I
DX8000-7spr 21.10.2004 10:29 Uhr Seite 4
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rowenta DX8300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rowenta DX8300 in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info