GB
5
VERY IMPORTANT
• Do not cover the air inlet and outlet grills.
• Do not touch the appliance with wet hands.
• The design of this IP21 appliance means it can be used in all parts of the house, including those with risks of
falling water (kitchen, bathroom, etc.).
• The electrical installation of the room and the way the appliance is installed and used must however conform
to the standards in your country.
• The appliance must be installed such that the control buttons cannot be reached by a person using the bath
or shower.
• Never use the appliance in other than an upright position. Place the appliance on a at and stable surface.
• Do not place heavy objects or children on the appliance.
• Do not put anything in the tank.
• Stop your appliance with the On/Off button before disconnecting it.
• Turn off and disconnect the appliance before moving it.
• In case of prolonged absence: turn off the appliance with the button (A) and unplug it.
VOLTAGE
Before using your appliance for the first time, check that the supply voltage matches that indicated on the
appliance.
OPERATION
Before switching on your appliance, make sure that:
- the appliance is positioned in accordance with these instructions,
- the air inlet and outlet grills are completely unobstructed,
- the appliance is placed on a at and stable surface.
START-UP OF THE APPLIANCE
Plug the lead in and press the start button (A).
On the display, the pictogram (L) appears indicating the temperature and relative humidity of the room, as
well as the speed and humidity selected the last time the appliance was used.
Note: If the appliance is not in continuous operation, the compressor will only work if the humidity factor
selected is lower than the room.
HUMIDITY CONTROL Function
To set the target relative humidity, select one of the values, 70%, 60% or 50%, using the button (B).
If the 70% function is selected, this means that the air will be dehumidified until the relative humidity falls to
70%. The appliance will turn off automatically if the relative humidity is below 70% (the compressor will stop
but the fan will continue to operate). The compressor will start again if the relative humidity exceeds 70%.
The same applies if 60% or 50% is selected.
CONTINUOUS function
The unit dehumidies the room continuously if the CONTINUOUS function (O) is activated using button (B),
regardless of the ambient humidity.
SPEED Function
Press button (C) to select:
• : gentle ventilation
• : medium ventilation
