GB
4 • USING YOUR STEAM GENERATOR
During ironing, the temperature control
light located on the iron and the steam
indicator will go on and off according to
the temperature control.
1.
Open the flap to the cord storage compartment by undoing the catch.
2. Completely remove the cords from the storage compartment
and slot them into the notches on either side of the flap (6).
3. Close the door.
4. Connect your steam generator to a socket with an earth
connection.
5. Press on the illuminated on/off switch.
The steam indicator lights up while the boiler
is heating up.
When the indicator goes out
(after about 7 minutes), steam
is ready (7).
6. Fit the cord guide onto the positioning
button situated on the side of the base unit.
7. F it the steam cord over the loop (8).
You can use your appliance and start ironing.
Be careful:
The first time the appliance is used, there may be some fumes and smell but this is not harmful.
They will not affect use and will disappear rapidly.
(6)
(8)(7)
1. Place the iron’s temperature control to the setting
suitable for the type of fabric to be ironed (9).
•
Synthetics (Low temperature)
••
Silk/Wool (Medium temperature)
•••
Cotton/Linen (High temperature)
With delicate fabrics (
•
setting), press the steam
control button (under the handle of the iron)
intermittently to avoid water droplets appearing with the steam.
2. The iron temperature control light turns on.
Be careful: the generator and the iron are ready to use when both
the iron’s thermostat light and the “steam ready” indicator go out.
If necessary, also adjust the steam output (steam output control dial
on the control panel) (10), eg : less steam for low temperatures.
3. To obtain steam, press on the steam control button beneath
the iron handle and keep it pressed (11).
The steam will stop when you release the button.
Note: It is normal for the connection cord to become warm
during use.
(9)
(10)
(11)
